AFINIBOT A9 User manual

Equipment assembly instructions
I. Open the packaging, accordance packing list, check the parts are intact.
II. Z axis assembly
1. Assemble Z Axis Frame
Two of Each M5 * 8 screws
and M5 T-nuts

2. Assembled Z-axis fixed block
3. Install the Z-axis limit switch
4. Install Z-axis motor
End with Inside Screw upside
Holding two planes on the same plane
Four of each M4 * 8 screw
and M4 T-nut
Two of each M4 * 10 screw
and M4 T-nut
One M5 * 12
screw
Two M3 * 16 screws
Two of each M4 * 14 flat head
screws and T-nuts

III. Install X axis
First locking M4 * 14
Then lock M3 * 16
Prevent the motor end
of the Z-axis tilt
Counterclockwise
rotation Z-axis
screw
Pressing Teflon pipe joint,
locking Teflon tube

I. Install handle
IV. Circuit wiring
1. Motherboard wiring diagram
Two
M5 * 12 screws

2. The physical wiring diagram
E Extruder Motor
X-Axis Motor
X-Axis Limit Switch
Y-Axis Motor
Y-Axis Limit Switch
Z-Axis Limit Switch
Z-Axis Motor

3. Motherboard physical wiring diagram
V. Install base
Nine M3 chassis screws

VI. Installation Completes