MakerBot Replicator 2 User manual

MakerBot Replicator 2
3D Printer
Quick Start Guide

1. Turn on computer connected to the MakerBot Replicator 2.
2. Locate power switch in the bottom rear of the MakerBot Replicator 2 and turn on.

LOADING AND PRINTING A FILE
1. Open a web browser on the computer and visit: http://www.thingiverse.com

3. Open MakerWare located on the desktop of the computer.

When you are ready to print, select the big “m” Make button at top center of screen and be sure to check off
“Preview before printing” at the bottom of the window that opens. This will enable you to get an estimated
time of how long the print will take (see next page).
Select Raft and/or Supports if needed.

Take note of print time shown at top right of window. You will only be permitted to continue with your print
job if you have enough time considering MakerStudio closing time and/or your reservation. The 3D printer
must be shut down at closing time regardless of time remaining in print job. Please talk with the MakerStudio
staff if your print job requires a longer time than is available.
If you have enough time and wish to initiate your print, select the Make It! button at the bottom of the
window.