Agilent Technologies 34450A User manual

Agilent Technologies
Agilent 34450A
5½Digit Multimeter
Quick Start Guide

II 34450A Quick Start Guide
Notices
© Agilent Technologies, Inc., 2012
No part of this manual may be reproduced in
any form or by any means (including elec-
tronic storage and retrieval or translation
into a foreign language) without prior agree-
ment and written consent from Agilent
Technologies, Inc. as governed by United
States and international copyright laws.
Manual Part Number
34450-90007
Edition
First Edition, October, 2012
Agilent Technologies, Inc.
5301 Stevens Creek Blvd.
Santa Clara, CA 95052 USA
Warranty
The material contained in this docu-
ment is provided “as is,” and is sub-
ject to being changed, without notice,
in future editions. Further, to the max-
imum extent permitted by applicable
law, Agilent disclaims all warranties,
either express or implied, with regard
to this manual and any information
contained herein, including but not
limited to the implied warranties of
merchantability and fitness for a par-
ticular purpose. Agilent shall not be
liable for errors or for incidental or
consequential damages in connec-
tion with the furnishing, use, or per-
formance of this document or of any
information contained herein. Should
Agilent and the user have a separate
written agreement with warranty
terms covering the material in this
document that conflict with these
terms, the warranty terms in the sep-
arate agreement shall control.
Technology Licenses
The hardware and or software described in
this document are furnished under a license
and may be used or copied only in accor-
dance with the terms of such license.
Restricted Rights Legend
U.S. Government Restricted Rights. Soft-
ware and technical data rights granted to
the federal government include only those
rights customarily provided to end user cus-
tomers. Agilent provides this customary
commercial license in Software and techni-
cal data pursuant to FAR 12.211 (Technical
Data) and 12.212 (Computer Software) and,
for the Department of Defense, DFARS
252.227-7015 (Technical Data - Commercial
Items) and DFARS 227.7202-3 (Rights in
Commercial Computer Software or Com-
puter Software Documentation).
Safety Notices
CAUTION
A CAUTION notice denotes a haz-
ard. It calls attention to an operat-
ing procedure, practice, or the like
that, if not correctly performed or
adhered to, could result in damage
to the product or loss of important
data. Do not proceed beyond a
CAUTION notice until the indicated
conditions are fully understood and
met.
WARNING
A WARNING notice denotes a
hazard. It calls attention to an
operating procedure, practice, or
the like that, if not correctly per-
formed or adhered to, could result
in personal injury or death. Do not
proceed beyond a WARNING
notice until the indicated condi-
tions are fully understood and
met.

34450A Quick Start Guide III
Safety Symbols
The following symbols on the instrument and in the documentation indicate precautions
which must be taken to maintain safe operation of the instrument.
Environmental Conditions
This instrument is designed for indoor use and in an area with low condensation. The table
below shows the general environmental requirements for this instrument.
Earth (ground) terminal Caution, risk of electric shock
Frame or chassis terminal Caution, risk of danger (refer to this manual
for specific Warning or Caution information)
IEC Measurement Category II. Inputs may be
connected to mains (up to 300 VAC) under
Category II overvoltage conditions.
CAT II
300 V
Environmental Conditions Requirements
Operating temperature Full accuracy at 0 °C to 55 °C
Operating humidity Full accuracy up to 80 % R.H at 30 °C
(non-condensing)
Storage temperature –40 °C to 70 °C
Altitude Operating up to 3,000 metres
Pollution degree Pollution Degree 2
NOTE
The Agilent 34450A 5½ digit dual display multimeter complies with the following
EMC and safety requirements:
• IEC 61010-1:2010 / EN 61010-1:2010 (3rd Edition)
• IEC 61326-1:2005 / EN61326-1:2006
• CISPR 11:2003 / EN 55011:2007 Group 1 Class A
• Canada: ICES/NMB-001:Issue 4, June 2006
•Australia/New Zealand: AS/NZS CISPR 11:2004

IV 34450A Quick Start Guide
Regulatory Markings
Additional Safety Information
For further information on safety, refer to the 34450A User’s Guide.
The CE mark is a registered trademark
of the European Community. This CE
mark shows that the product complies
with all the relevant European Legal
Directives.
The C-tick mark is a registered
trademark of the Spectrum
Management Agency of Australia. This
signifies compliance with
the Australia EMC Framework
regulations under the terms of the
Radio Communication Act of 1992.
ICES/NMB-001 indicates that this ISM
device complies with the Canadian
ICES-001.
Cet appareil ISM est confomre a la
norme NMB-001 du Canada.
This instrument complies with the
WEEE Directive (2002/96/EC) marking
requirement. This affixed product label
indicates that you must not discard
this electrical or electronic product in
domestic household waste.
The CSA mark is a registered
trademark of the Canadian Standards
Association.
This symbol indicates the time period
during which no hazardous or toxic
substance elements are expected to
leak or deteriorate during normal use.
Forty years is the expected useful life
of the product.

34450A Quick Start Guide V
Contents
Standard Shipped Items 1
The Front Panel at a Glance 2
The Display at a Glance 3
The Rear Panel at a Glance 4
Locking and Unlocking the Front Panel Keys 5
Adjusting the Carrying Handle 6
Selecting Measurement Functions 7
Selecting Resolution/Speed 8
Using the Dual Display 9
Accessing Null Function 10
Accessing Math Function 10
Editing Math Values 11
Connecting Test Leads to the Terminals 12
NOTE
For further information on any topics mentioned in this Quick Start Guide,
please refer to the 34450A User’s Guide.

VI 34450A Quick Start Guide
THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK.

34450A Quick Start Guide 1
Standard Shipped Items
Agilent 34450A 5½Digit Multimeter
Certificate of
Calibration
Product
Reference CD ROM
Agilent IO Library
Suite CD ROM
Quick Start Guide
USB Interface cableTest Kit Leads
Power Cord
88.5mm
272.3mm
212.6mm

234450A Quick Start Guide
The Front Panel at a Glance
1
4
2
358
11710 9
6
NOTE
For a complete list of all keypad functions and descriptions, please refer to
Chapter 1, “Getting Started Tutorial” in the 34450A User’s Guide.
Display
Power ON/OFF Switch
Measurement functions
Math Operations
State Store/Recall, Utility Menu
Data Log, View
Auto range and Manual range
Resolution, Measurement Speed
SHIFT (selects blue shifted keys) and Local Key
Secondary Display Key
Input Terminals
1
2
3
7
4
5
6
8
9
10
11

34450A Quick Start Guide 3
The Display at a Glance
Single Display Screen
Figure 1-1 Typical single display screen
Dual Display Screen
Figure 1-2 Typical dual display screen
NOTE
For a complete list of all annunciator descriptions, please refer to Chapter
1, “Getting Started Tutorial” in the 34450A User’s Guide.

434450A Quick Start Guide
The Rear Panel at a Glance
Figure 1-3 Rear panel at a glance
1
3
25
46
78 9
10
7
Serial Interface Connector
USB Interface Connector
GPIB with Option 3445GPBU installed
Current Fuse
Model and Serial Number Label
Kensington Lock
Chassis Ground Lug
AC Power Connector
AC Line Fuse
AC Line Voltage Selector
1
2
3
4
5
6
7
8
9
10