aidapt VA121S Programming manual

EN
Scooter or Wheelchair Lap Straps
Usage and Maintenance Instructions

Usage and Maintenance Instructions Ver. 3 05/2013 (2235)
2
INTRODUCTION
Thank you for deciding to purchase the Scooter or Wheelchair Lap Strap from
Aidapt. The Scooter or Wheelchair Lap Strap is manufactured from the finest
materials available.
When used correctly it is designed to give many years of reliable, trouble-free
service.
VA121 Lap Strap for Wheelchairs
VA121S Lap Strap for Wheelchairs or Scooters
NB. This eq ipment m st be installed by a competent person.
BEFORE USE
Carefully remove all packaging. Avoid using any knives or other sharp instruments
as this may damage the item.
Check the product for any visible damage f you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
Before use ensure that the strap is threaded through the buckles and the snap
fastener correctly, as in Fig. 1.
Fig. 1
INTENDED USE
Our safety lap straps use a snap lock fastener and are adjustable to fit. They are
available in two styles;
The VA121 is secured around the backrest or armrest of the frame and is primarily
for use on wheelchairs.
The VA121S passes entirely around the seat back and is mainly for use with scooters
but can also be used with wheelchairs.

Usage and Maintenance Instructions Ver. 3 05/2013 (2235)
3
FITTING INSTRUCTIONS
VA121: Remove the buckle and clasp from the strap first and then loosen enough
screws from the back panel of the wheelchair (enough to allow the strap to be
passed between the back of the chair and the frame). Pass the free end of the strap
around the back of the chair and thread through the metal slide ring, make sure to
pull the strap tight. Make sure to tighten all loosenedscrews and replace the buckle
and clasp on the strap. (See Fig. 2)
VA121S: Form a loop through the buckle at one end of the strap (see Fig. 3), pass
this over the arm of the wheelchair and pull the loop tight (Fig. 4). Pass the strap
around the back of the wheelchair and make another loop at the other side, again
passing this over the arm.
Fig. 2 Fig. 3 Fig. 4
CLEANING
Clean your Scooter or Wheelchair Lap Strap using a mild detergent with a slightly
damp, soft cloth only. Only use a mild detergent or disinfectant; never use an
abrasive cleaner.
After cleaning, leave the strap somewhere warm and dry to air. Do not leave in
direct contact with a heat source.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any
concerns.
REISSUE
f you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
If in any do bt, please do not iss e or se, b t immediately contact yo r
s pplier for service s pport.

Usage and Maintenance Instructions Ver. 3 05/2013 (2235)
4
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part
of or establishing any contractual or other commitment by Aidapt Bathrooms
Limited, Aidapt (Wales) Ltd or its agents or its subsidiaries and no warranty or
representation concerning the information is given.
Please exercise common sense and do not take any unnecessary risks when using
this product; as the user you must accept liability for safety when using the
product.
Please do not hesitate to contact the person who issued this product to you or the
manufacturer (detailed below) if you have any queries concerning the
assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane, S tton Oak, St Helens, WA9 3EX
Telephone: [phone] • Fax: [phone] • Web: www.aidapt.co. k
Email: acco [email protected]. k • [email protected]. k • [email protected]. k