Aim MyChron5 Installation guide

Expansions
1
www.aim-sportline.com Release 1.01 – October 11th 2017
Showing LCU-One CAN data on MyChron5
Answer:
How can I see data sampled by LCU – One CAN on MyChron5 display?
Answer:
Connect LCU – One CAN to MyChron5 and follow this procedure:
•press “MENU/<<” button
•select “System Settings” and press “ENTER”
•select “Display Setup” and press “ENTER”
•choose a custom page, enable it and press “CONFIG”

Expansions
2
www.aim-sportline.com Release 1.01 – October 11th 2017
The page shows 4 fields all set as “NONE” with the top left one selected.
•press “SELECT”
•use “PREV” and “NEXT” button to scroll the list of available values;
•the LCU-One values you can see are:
oLambda Val (that will be labelled Lmd) corresponding to the ration oxygen/air in the
exhaust gas – reference value is 1.00
oLambda AFR (label AFR) corresponding to lambda value multiplied by the stochiometric
value of the fuel you are using (i.e. petrol stochiometric value is 14.57)
oLambda Temp (labelled LmdT) corresponding to the probe internal temperature
•select the desired value and press “SELEZ”; repeat the operation for the three values
•at the end MyChron5 will show all fields set: press “EXIT” until you reach MyChron5 home page
•press “ON/VIEW” until you reach LCU page you configured and you will see in real time the values
of the fields you set.