Aiphone JB-DVF-HID User manual

Vandal Resistant Color Video Door Station
With Built in Proximity Card Reader
JB-DVF-HID
(front view)
JB-DVF-HID
(back view)
- INSTRUCTIONS-
The JB-DVF-HID is a JB-series color video door station and an HID ProxPoint Plus Card Reader,
built onto the same stainless steel faceplate. The card reader provides electronic access to a
building through a separate Access Control System, which is not supplied by Aiphone.
11-⅝”
INSTALLATION:
1. For flush mounting, cut hole in wall and use supplied back box.
Box dimensions are 4-½”W x 10-⅜”H x 1-¾”D.
2. For surface mounting, use the SBX-DVF-P surface mount box.
This box can mount to a standard 1- gang box or to any flat surface.
20" pigtail cable
Wiegand Wire Color
+ DC (5-16V) Red
Ground Black
Data0 Green
Data1 White
Shield Ground Drain
Green LED Orange
Red LED Brown
Beeper Yellow
Hold Blue
Card Present Violet
Pg. 1
Connecting the Reader to the Host:
Connect the reader to the host according to the
wiring table below and the host installation guide.
5-¾”

Master
JB-2M(E)D
JB-DVF-HID
PS-1820UL
+
-
+
-
1A1
1A2
B1
B2
2A1
2A2
S
S
A1
A2
Output to Host
Access Control System
WIRING DIAGRAM:
TESTING AND OPERATION:
When power is applied to the card reader, the LED will flash green three (3) times while
the beeper beeps simultaneously. The LED will then turn red. This indicates that the
microcontroller is operating properly.
Present an ID card to the reader. (Hold card directly in front of reader.) The LED will
momentarily turn green while the beeper beeps once, indicating that the card was read
successfully.
CARD READER:
Power Source: 5.0 ~ 16V DC
Absolute Max. Voltage: 18V DC
Peak Current: 80mA
Avg. Current 5V or 12V: 20mA
Terminations: Color-coded pre-wired pigtail
Wiring Distance: 500'
Operating Temperature:-10° ~ 60° C / 14° ~ 140° F
SPECIFICATIONS: CAMERA:
Camera unit: CCD Camera
Scanning line: 525 lines
Min. illumination: 1 Lux or less at 1'
Terminations: Screw terminals
Wiring Distance: 330' w/871802 wire
980' w/JBW-BA & 851602 wire
Dimensions(camera): 5-¾” W x 11-⅝” H x 1-5/16" D
With SBX-DVF-P: 5-15/16" W x 11-¾” H x 2-13/16" D (Top)
1-15/16" D (Bottom)
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
[phone]
FAX [phone]
TOLL FREE TECHNICAL SUPPORT: [phone]
TOLL FREE FAX LINE: [phone]
E-MAIL: [email protected]
Pg. 2
JB-DVF-HID Instr.
0706JDJS
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the
power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certified power supply.