Aiphone JP-DVF-PR User manual

1
The JP-DVF-PR is a JP Series video door station with a built-in AC-PROX-1G proximity card reader. The station connects directly to a
JP-4MED master station using 2-conductor wire, and the card reader uses a standard Wiegand connection to connect to a compatible
access control system.
JP-DVF-PR
INSTALLATION GUIDE
1. Camera
2. Microphone
3. White LED for low light illumination
4. Speaker
5. Directory card
6. Call button
7. Card reader
• PTZ camera
• Stainless steel faceplate
• Built-in RFID card reader
Features
For ush mounting, recess the supplied back box into the wall,
then attach the mounting bracket using the four provided bracket
screws.
Back Box Dimensions: 10-1/2" H x 5-13/16" W x 2-5/16" D
JP-DVF-PR Dimensions: 11-11/16" H x 7" W x 2-1/16" D
For surface mounting, use the SBX-IDVFRA surface mount box.
This box can mount to a standard single-gang box or to any at
surface.
To insert the transparent nameplates, remove the vandal-
resistant front panel from the ush mount back box. Peel o󰀨 the
protected seals from both sides of the plate. Write in the desired
text, being sure to leave 1" of white space on the right side.
Insert the nameplate into the opening.
Installation
Package Contents
JP-DVF-PR
Door Station
Security Driver
Transparent
nameplate (2)
Flush mount backbox
and tamper-resistant screws
1
2
5
4
3
7
6
JP-DVF-PR Names and Functions

For more details about the features and information above, please contact Technical Support.
204/23
Aiphone Corporation | www.aiphone.com | [phone]
Wiring Diagram
Card Reader
Reader Type: 125kHz Proximity Card
Reader
Reader Model: AC-PROX-1G
Power Source: 5 ~ 16V DC
Current: 30mA (average); 75mA (peak)
Terminations: Color-coded pre-wired pigtail
Wiring Distance: 500'
Operating Temp: -31°~150°F (-35°~66°C)
Operating Humidity: 0% to 90% relative humidity
non-condensing
Connect theConnect the
reader to thereader to the
access controlaccess control
host accordinghost according
to the host'sto the host's
installation guide.installation guide.
1A1
1A2
A1
A2
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Wiegand Wiring
Conductor Function
Red 5 ~ 16V DC
Black Ground
Green Data 0
White Data 1
Brown Red LED
Orange Green LED
Yellow Card Present
Blue Beeper
Violet eaPower
Drain Shield Ground
Specications
Door Station
Camera Unit: 1/4" color CMOS
Scanning Line: 525 lines
Min. illumination: 5 Lux
Terminations: Screw terminals
Operating Temp: -4°~140°F (-20°~60°C)
Wiring Distance: 330'
Dimensions: 11-11/16" H x 7" W x 2-1/16" D
w/ SBX-IDVRA: 11-11/16" H x 7" W x 3-5/16" D
JP-4MED
JP-DVF-PR
Access
Control Host PS-2420UL