Air-Aqua SuperBead Automatic User manual

SuperBead Automatic
The SuperBead automatic:
1. 3 x Sockets for the pondpump(s) and UV Lamp(s) Max. 8A/250VAC
2. Plug for power electronics 16A/250VAC
3. Socket for cleaning pump Max. 8A/250VAC
4. Cable for 3 way valve motor
5. Screws for mounting 3 way valve motor
6. Motor for valve 1A/24VAC

Placing the engine on the 3 way
valve
1. Verwijder de kunststof
schroef van de hendel
2. Remove the plastic screw
on the handle
3. Now you see on the 3 way
valve 4 notches (A)
You see in the motor 4
pins (B)
Now place the engine on
the 3-way valve NOTE
smallest pin must fall into
the smallest notch
4. Now turn the engine so,
that it just as the picture
shows
5. Now place the 4
screws into the 4 holes
6. Tightenthescrewsnger
tight
7. You now turn the plastic
screw without lever on the
engine

SuperBead Automatic
What do the various LEDs
1 ONTheushisON
OFF The rinsing is OFF
2 ON Flush pump is ON
 OFFTheushingpumpisOFF
3 ON The pond pump delay is turned ON (1 minute)
OFF The pond pump delay STANDBY
4 ON The pond pump is turned OFF (1 minute)
OFF The pond pump is turned OFF
5 ON The electronics has WEL voltage
OFF The electronics has NO power

Setting the timer
1. Resetrst,pressingthetimerbyR
2. To adjust the time hold C +, push W+(days) H+ (hours) and M+(minutes)
Setushtime
1. Press 1 time on the clock symbol, now you see ON 1 left bottom.
Now set with the buttons W + (days) H + (hour) and M + (minutes).
2. Press 1 x on the clock symbol, now you see OFF 1 left bottom.
Now set with the buttons W + (days) H + (hour) and M + (minutes).
Manuallyactivateushing
1. Press the manual button, under the screen there will be ON, AUTO or OFF seen.
 IfyouwanttosetupanautomaticrinsetheclockneedstoOFFrstandthenpush
again to be on AUTO.
Apropercleaningcyclecanhaveamaximumdurationofushing:
Small SuperBead 40 seconds
SuperBead Large 2 minutes
Thereisalsothepossibilitytoconnectaushingpump.Thereforyoucanuseacheaper
pond pump (20m3 SB Small & 30 m3 SB Large), you can pull water directly out of the
lterandpumpittothesewer.
Is the valve for your application in the wrong position, you can change this with the
AUTO ON1 and AUTO ON2 button.