Air hogs Zero gravity micro User manual

FOR INDOOR USE ON Y.

ADU T SUPERVISION RECOMMENDED!

TO GET THE MOST OUT OF

YOUR ZERO GRAVITY MICRO™

WA RACER P EASE READ THESE

INSTRUCTIONS FIRST!

NOTE:

USE ON SMOOTH, C EAN

SURFACES ON Y!

Check to make sure contents are

complete:

• 1 Zero Gravity icro™ Wall Racer

• 1 Controller/Charger

• 1 Instruction Sheet

INSTRUCTIONS

INSTA BATTERIES

CLOSE OPEN

Controller/Charger

Battery

Compartment

Door

Six

1.5-V AA

Alkaline

Batteries or

Rechargeable

Batteries

Battery

Compartment

CHARGING YOUR ZERO GRAVITY MICRO™WA RACER

1. Switch

car to

“OFF”.

3. Take

out

charge

nozzle.

4. Plug cable

into port

of vehicle.

ake sure

the arrow is

on top.

6. Green light

flashing: Vehicle

is charging.

Green light off:

Vehicle is charged.

• Charging should take between 30 and 50 minutes depending on how much charge is left in car.

•NOTE: Do not charge battery immediately after use. Let car battery cool for at least 10 minutes. If charging is not complete in 50 minutes,

replace the charger batteries.

Your Zero Gravity Micro™Wall Racer has a pre-installed rechargeable

battery inside the vehicle body.

2. Switch

controller/

charger to

“OFF”.

5. Slide

switch on

controller/

charger to

“CHARGE”.

7. When charged,

turn controller/

charger switch

“OFF”.

8. Stow

charge cable

in storage

compartment.

PROB EMS? Before you return to retailer, please call our HOTLINE for assistance,

1-800-622-8339

Zero Gravity Micro™

Wall Racer

Controller/Charger

All manuals and user guides at all-guides.com

all-guides.com

Stand at least

4’ from the wall.

WHI E DRIVING YOUR ZERO GRAVITY MICRO™WA RACER,

MAKE SURE TO FO OW THESE RU ES

Only drive on smooth, clean,

dry surfaces. ake sure walls are clear

of obstacles, including hanging pictures,

light switches, etc...

Do not drive on uneven,

porous, or broken surfaces, as vehicle

will not adhere and can fall off.

Do not drive to or off

the edge of the wall.

The Zero Gravity

icro™ Wall Racer has

working headlights.

IMPORTANT: When the headlights begin to blink, the

rechargeable battery is running low on power. Car should

be removed from the wall immediately. Otherwise the

vehicle may fall off the wall.

PROB EMS? Before you return to retailer, please call our HOTLINE for assistance,

1-800-622-8339

All manuals and user guides at all-guides.com

TRIM ADJUSTMENT

PROB EMS? Before you return to retailer, please call our HOTLINE for assistance,

1-800-622-8339

DRIVING ON WA S OR UPSIDE DOWN

To drive on walls upside down you must put the vehicle in

the WALL mode.

NOTE: Avoid driving overhead when other people are

around. Do not stand underneath when driving overhead.

DRIVING ON THE GROUND

To drive on the ground you must put the vehicle in the

GROUND mode.

The fan will not turn ON, but the headlights will turn on and

the vehicle will drive full function on the ground. (The ground

mode saves the battery charge).

Place the vehicle in the ground mode and drive forward

without touching the right joystick. If the vehicle turns to the LEFT, press the Right trim button

until it drives straight (A).

If the vehicle turns to the RIGHT, press the Left trim button

until it drives straight (B).

The fabric air skirts can be adjusted outward at a 45° angle

to ensure a proper wall suction.

IMPORTANT: The Zero Gravity icro™ should only be

driven on a smooth, clean, flat surface. Dirt or debris can

get inside the fan and cause damage.

When finished playing with your Zero Gravity Micro™,remove vehicle from wall.

Turn vehicle OFF. Turn the controller OFF. NOTE: The trim setting will reset when the vehicle and controller are turned off.

All manuals and user guides at all-guides.com

IMPORTANT BATTERY INFORMATION:

• Do not mix old and new batteries.

• Do not mix alkaline, standard or rechargeable batteries.

• Battery installation should be performed by an adult.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the toy before

being charged (if removable).

• Rechargeable batteries are only to be charged under adult

supervision.

• Only batteries of the same or equivalent type as

recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short circuited.

• Different types of batteries, or new and used batteries are

not to be mixed.

• Exhausted batteries are to be removed, as they will adversely

affect the performance.

Your Zero Gravity Micro™is equipped with a ithium Polymer battery.

WARNING:

• Do not leave the toy unattended while charging it.

• Battery charging should be done by adults.

• Charge the toy on a non-flammable surface and keep it away from flammable items.

• Do not expose battery to direct sunlight. There is a risk of the battery exploding, overheating, or igniting.

• Do not disassemble, modify, heat, or short circuit the battery.

• Do not place battery in fires or leave in hot places.

• Do not drop or subject to strong impacts.

• Do not allow the battery to get wet.

• Only charge the battery with the specified Air Hogs®battery charger.

• Only use the battery in the device specified by Air Hogs®

• Turn the charger off when the toy’ s battery is charged, and always unplug it from the toy.

• Disconnect AC wall chargers from outlets while not in use.

• If the toy has been damaged, immediately stop use, unplug, and safely move the toy away from flammable materials.

• Follow the manufacturer’ s instructions for charging the toy. Do not charge longer than recommended.

• Carefully read the instruction manual and use the battery correctly.

RIGHT SPIN

By pushing the joystick on the controller/charger, you can make your Wall Racer spin around on the spot.

Push the RIGHT joystick to the right to

make the vehicle spin clockwise. Push the RIGHT joystick to the left make

the vehicle spin counter-clockwise.

SPINS

TROUB ESHOOTING

Spin aster Ltd., 450 Front Street West, Toronto, ON 5V 1B6 Canada

Spin aster Inc., P B #10053, 300 International Drive, Suite 100, Williamsville,

NY 14221, USA

Spin aster Toys Far East Limited. Rm #1113, 11/F, Chinachem Golden Plaza,

77 ody Rd., Tsimshatsui E., Kowloon, HK

Spin aster Toys UK Ltd., eadowbank, Furlong Road, Bourne End, Bucks,

SL8 5AJ, United Kingdom

Spin aster France – 36 rue de Silly – 92100 Boulogne Billancourt – France

North American Consumer Information

Phone: 1-800-622-8339

www.spinmaster.com

registered trademark of Spin aster Ltd. All rights

reserved. Conforms to product safety standards

AST F963, regulatory requirements. Products and

colors may vary. Please retain this information for

future reference. Patent Pending.

ADE IN CHINA.

Asst. #44317 NEN REV 1

PROB EM

Vehicle will not run.

Vehicle does not climb.

Vehicle does not drive straight.

Vehicle slips climbing the walls.

Vehicle falls off the wall.

Vehicle will not climb walls.

SO UTION

1. Power switch is off. Turn on.

2. Controller battery is installed with incorrect polarity. Check the (+) and (-) markings to make sure the

battery is properly aligned.

3. Batteries are drained. Charge batteries and/or install new batteries.

1. Over current protection is engaged. Turn vehicle off for 30 seconds then restart.

1. Check trim.

2. ake sure surface is clean of dirt/dust.

3. ake sure surface is neither too rough or too smooth.

4. ake sure surface is flat.

1. Clean the tires with a damp rag.

2. Fold up the fabric skirts for a better seal prior to use.

1. ake sure to discharge and then charge again for 30 to 50 minutes.

2. Clean tires and make sure your wall and floor are also clean.

3. Check the fabric skirts for damage. If they have been pulled loose, tape them back on with flexible tape.

4. ake sure surface is flat.

1. Suction jammed. CA 1-800-622-8339.

Contains iPo battery

pack. Battery pack

must be recycled or

disposed of properly.

STI HAVING PROB EMS? Before you return to retailer, please call our HOTLINE for assistance,

1-800-622-8339

EFT SPIN

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures: •Reorient or relocated the receiving antenna. •Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •Consult the dealer or an experienced radio/TV technician for help.

FCC REQUIREMENTS