Airlink101 AGSW801 User manual

8-Port 1000/100/10Mbps
Gigabit Switch
User’s Manual

1
P
Front Panel
LED Name Color Light Status Description
On The switch is powered on.
PWR Green
Off The switch is powered off.
On LAN port is connected.
Off LAN port is not connected.
1-8 PORT
LNK/ACT Green Flashing LAN activity (transferring or
receiving data).
Yellow On The LAN port is running at
1000Mbps
Green On The LAN port is running at
100Mbps.
1-8 PORT SPEED
(10/100/1000M) Green/ Yellow
Off The LAN port is running at
10Mbps.
1 Physical Description

2
Rear Panel
Item Name Description
Power Power connector, connects to A/C power adapter.
1 - 8 1000/100/10Mbps Local Area Network (LAN) ports 1 to 8.

3
1. Operating Environment
This switch must be installed and operated within the limits of specified
operating temperature (32-1310F) and humidity (10-90%
Non-condensing). Do not place objects on top of the unit. Do not obstruct
any vents at the sides of the unit. Do not position the unit near any
heating source such as heater, radiator, or direct exposure to sun. Prevent
entering of water and moisture into the unit. If necessary, use
dehumidifier to reduce humidity.
2. Connecting to network devices
The RJ-45 ports on the switch support Auto-MDI/MDI-X function which
allows using straight-through or cross-over type cables to connect this
switch to workstation or hub.
Connect one end of the network cable to the RJ-45 port on the rear panel,
and connect the other end of the network cable to the RJ-45 port on the
network device. Follow the same procedure to connect all the RJ-45 ports
of the switch. The UTP network cables must be four pairs Category 5
standard for 1000Mbps data transmission; two pairs Category 5 for
100Mbps data transmission; two pairs Category 3, 4 or 5 standards for
10Mbps data transmission. Maximum length, using UTP cable, between
the switch and connected device is 100 meters (300ft). Once the network
cable is connected to both ends and the attached network device is
powered on, the green LNK/ACT LED should be lit.
3. Connecting the power
Connect the output end of the power adapter to the power connector on
the rear panel of the switch. Connect the power adapter to the power
outlet. The green Power LED on the front panel should be lit.
2 Install the Gigabit Switch

4
1. Power LED is not lit
Check if the power adapter is properly connected to the power outlet.
Make sure the power jack is firmly plugged into the power socket of the
switch.
2. Link/Activity is not lit when connect to 1000/100/10Mbps device
•Check the power switch of the network device attached to the switch;
make sure it is turned ON.
•Check the network cable; make sure it is properly connected to the
switch and the network device.
•Check the network cable; make sure the UTP cables comply with the
specifications described in Chapter 2.
[!] Contact your dealer if problem persist.
3 Troubleshooting