AirLive PJ-1001-30W User manual

Aug. 9, 2021
Ver. 1.0
PoE Injector
PJ-1001-30W
User Manual

ii AirLive PoE Injector
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means, whether
electronic, mechanical, photocopying, or recording without the written consent of AirLive
Technology Corp.
AirLive Technology Corp has made the best effort to ensure the accuracy of the information
in this user’s guide. However, we are not liable for the inaccuracies or errors in this guide.
Please use with caution. All information is subject to change without notice
All Trademarks are properties of their respective holders.
Disposal
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmentally safe recycling.

1
Table of Contents
1. Overview................................................................................................... 2
1.1 Connecting PJ-1001-30W.................................................................. 3

2 AirLive PoE Injector
1
1. Overview
Ethernet 802.3at PoE Injector (PJ-1001-30W)
The AirLive PJ-1001-30W Gigabit Ethernet POE Injector is fully compatible with IEEE802.3af
(15.4W) and IEEE802.3at (30W). The POE port supports a maximum output power of 30W, and the
port supports 10/100/1000Mbps self-adaption. It supports AC 100-240V voltage input; the working
temperature range is -20°C ~ +50°C, seamless ultrasonic bonding, better protection effect. It takes
the electricity from the power source and the data from the Ethernet network and then combines
them into a signal that can be transmitted through the UTP/STP cable up to 100m.
The product can be widely used in IP Camera, AP, 30W PoE PC-Panel, AP, digital signage display
system, PoE LED, etc. Its reliable hardware design can ensure your automation system runs without
interruption and stability.
PJ-1001-30W

1
1.1 Connecting PJ-1001-30W
Power on the device by connecting the AC cable first. Connect a RJ-45 cable from a switch/router
to the PoE Injector’s port called Data In, this is Data only. From the PoE Injector’s PoE Out port a
RJ-45 cable can now be used to Power On and transfer Data for, for example a PoE Camera or
Access Point. The PoE Out port has both Power and Data.
For more detailed specifications please see the datasheet.
The datasheets can been found online on www.airlive.com
** Specifications are subject to change and improvement without notice.
AC Input
Green LED: Power On