AirLive AIRCAM WL-350HD User manual

A
irCam
W
L-350HD
Auto Light Sensor Wireless-G
MegaPixel IP Camera
Use
r
’s Manual

Copyright and Disclaimer
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means, whether
electronic, mechanical, photocopying, or recording without the written consent of OvisLink
Corp.
OvisLink Corp. has made the best effort to ensure the accuracy of the information in this
user’s guide. However, we are not liable for the inaccuracies or errors in this guide.
Please use with caution. All information is subject to change without notice
All Trademarks are properties of their respective holders.

AirLive AirCam WL-350HD User’s Manual
FCC Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. For
product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any
other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.

i AirLive AirCam WL-350HD User’s Manual
Table of Contents
1.Overview...................................................................................................3
1.1 Introduction..............................................................................3
1.2 Features ..................................................................................3
1.3 Product Specification ...............................................................3
1.4 System Requirement ...............................................................4
2.Package Contents and Installation ........................................................5
2.1 Hardware Overview .................................................................6
2.2 Hardware Installation...............................................................7
2.3 Connect to IP Camera .............................................................8
3.Using IP Camera via Web Browser ......................................................10
3.1 Windows Web Browser .........................................................10
3.2 Mac Web Browser .................................................................11
4.Setting up Wireless Configuration .......................................................13
5.Operating IP Camera via Mobile Phone ...............................................15
5.1 Mobile Phone Viewing ...........................................................15
5.2 Using IP Camera via iPhone .................................................16
6.MSN Messenger .....................................................................................17
7.Configuration of Main Menu .................................................................22
7.1 Live View ...............................................................................22
7.2 Setting ...................................................................................24
7.3 Client Setting .........................................................................25
7.4 Image Setup ..........................................................................26
8.Setting-Basic..........................................................................................27
8.1 System...................................................................................27
8.2 Camera..................................................................................31
8.3 Network .................................................................................43

AirLive AirCam WL-350HD User’s Manual ii
8.4 Security..................................................................................58
8.5.HTTPS...................................................................................60
8.6.IP Filter ..................................................................................61
9.Setting-Advanced ..................................................................................63
9.1 FTP Client..............................................................................63
9.2 SMTP.....................................................................................68
9.3 Network Storage ....................................................................75
9.4 HTTP Event ...........................................................................79
9.5 Schedule................................................................................82
9.6 Alarm Buffer...........................................................................83
9.7 Motion Detection....................................................................85
9.8 Audio Detection .....................................................................86
9.9 System Log............................................................................87
10.Appendix..........................................................................................88
A. Frame-rate and Bitrate Table............................................................88
B. Storage Requirement Table..............................................................92

3
1 1. Overview
This user’s guide explains how to operate this camera from a computer. User should read
this manual completely and carefully before you operate the device.
1.1 Introduction
Still couldn’t find a way to watch your children or the elders when you are in busy or on duty?
Or just need an easy solution for monitoring your office, store or garage? WL-350HD, with
its compact size and wireless network technology, moves the “surveillance” from a complex
task to a simply “Plug and Play” job.
1.2 Features
This manual will illuminate the steps of how to setup and operation this IP camera, so you’ll
also soon be enjoying the benefits of these product features:
Compact and thin design
UPnP for fast and easy installation
Support 6pcs high illumination LED
1.3 megapixel progressive scan CMOS
Multiple H.264, Motion JPEG and MPEG-4 video streams
Supports Two-Way Audio
Mobile Phone Live Viewing
Support Windows Live Messenger
32 channel surveillance software
1.3 Product Specification
Models AirCam WL-350HD
Image sensor 1/4” Progressive scan CMOS 1.3 Megapixel sensor
Lens F1.8, 4.2 mm
Digital Zoom 10x digital
Min Illumination 0 Lux at F2.0 with Night-vision LEDs on
IR working distance 5 M
Video Compression Motion JPEG
MPEG-4 Part2 (ISO/IEC 14496-2), Profile: SP
H.264 BP
Resolutions UP to 1280 x 1024

4
Frame rate Motion JPEG: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
MPEG-4: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
H.264: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
Video streaming Simultaneous Motion JPEG, MPEG-4, H.264 and
3GPP (4 streaming)
Audio Two-way (full duplex)
Wireless IEEE 802. 11b/g
Alarm and event
management
Input: alarm buffer, motion detection, audio detection
Output: network storage, FTP, SMTP, HTTP event
Pre-and post alarm buffer
Casing PC+ABS casing
Power 12V DC, 1A, Max 12W
Operating
conditions
0 ~ 50 ℃(32 ~ 122 ℉)
Supported
protocols
Bonjour, TCP/IP, DHCP, PPPoE, ARP, ICMP, FTP,
SMTP, DNS, NTP, UPnP, RTSP, RTP, HTTP, TCP,
UDP, 3GPP/ISMA RTSP
Dimensions
(HxWxD) and
weight
104 x 63 x 35 mm (4.1” x 2.5” x 1.4”)
116.5 g (0.3 lb) excl. power supply
Approvals CE, FCC, RoHS
1.4 System Requirement
For normal operation and viewing of the network camera, it’s recommended that your
system meet these minimum requirements for proper operation:
Item Requirements
CPU Pentium 4 2.8GHz (or equivalent AMD)
Graphic Card 256 MB RAM graphic cards(or equivalent on-board graphic
cards)
RAM 1G
Operating
System
Windows 2000, Windows 2003, Windows XP, Windows Vista,
Windows 7, and Mac OS X Leopard
Web Browser Internet Explore 6 or later
Note: Please keep updating the latest Windows software and service package. (Ex: Net
Framework, Windows Media Player, Enhance ActiveX Security)

5
User can find the following items in the package as below:
Item Descriptions
1. WL-350HD is the main
element of the product.
2. Stand and Mounting
Bracket
3. Bundle CD include Setup
Wizard II, Messenger Plug-in,
Quick Start Guide, User Manual
and other tools
4. Power Adapter dedicates
12V DC electric power output to
Network Camera.
5. Antenna
2 2. Package Contents
and Installation

6
6. Quick Start Guide provides
important information and
instructions for installing this
device.
2.1 Hardware Overview
Front and Lateral Side
Bottom Side
Network
Audio OutReset
Power In

7
2.2 Hardware Installation
Follow these steps to install the WL-350HD on your Ethernet:
Note:
Press the Reset Button to reboot the camera.
Hold the Reset Button for 10 seconds to restore the camera to default
1. Install Ethernet
Cable 2. Install Power Adapter
3. Install Stand 4. Install Antenna

8
2.3 Connect to IP Camera
A. Insert the bundle CD into your PC/Laptop
B. Auto Run Screen then shows up, click “Install Driver & Utility ÆIP Search Tool” to
install the configuration tool software
C. After complete installation, run the configuration tool software

9
D. The Software scans the network and finds the IP Camera, then list in the dialog box.
E. If the Camera’s IP address is in the same IP segment as your LAN, select the founded IP
Camera and double click on the item, then the default browser will show up and connect
to the IP camera’s Web automatically.

10
3.1 Windows Web Browser
A. Open your web browser, and enter the IP address or host name of the IP camera in the
Location / Address field of your browser.
Note: If you only want to view the video without accessing Setting screen, enter
“http://<IP>/index2.htm” as your web URL.
B. Use the default account “admin” and default password “airlive”.
Note : The default user name “admin” and the password “airlive” are set at the factory for
the administrator. You can change them in the Account Menu. (Please check “Setting →
Basic →Security →Account”)
C. The monitor image will be displayed in your browser. In the far left side of main
configuration are Setting, Client Setting, and Image Setup. For more details, you can
check Chapter 7.2、Chapter 7.3、Chapter 7.4 and Chapter 7.5.
3 3. Using IP Camera via
Web Browser

11
3.2 Mac Web Browser
A. Click the Safari icon, and enter the IP address of the IP camera in the Location / Address
field of your browser.
Note: If you only want to view the video without Setting screen “http://<IP>/index2.htm” as
your web URL.

12
B. Enter the default account “admin” and default password “airlive”.
Note: The default user name “admin” and the password “airlive” are set at the factory for
the administrator. You can change them in the Account Menu (Please check “Setting →
Basic →Security →Account”)
C. The monitor image will be displayed in your browser. In the far left side of main
configuration are Setting, Client Setting, and Image Setup. For more details, you can
check Chapter 7.2、Chapter 7.3、Chapter 7.4 and Chapter 7.5.

13
The wireless network has to be set up by using cable network connection. After setting the
camera correctly, the wireless function can work without cable network connection. Please
follow the setting process below step by step:
A. Connect IP Camera with Ethernet connection.
B. Go to “Setting →Basic →Network →Wireless,” choose option “On”. You will see the
wireless Setting screen.
C. Then click “Refresh”. All access points (AP) around you will show up.
D. Select the AP you wish to connect.
4 4. Setting up Wireless
Configuration

14
E. Enter password at active transmit key if you need. If you don't know the setting of the
wireless AP, please ask your network administrator.
F. Choose the option of Obtain an IP address automatically (DHCP) and Obtain DNS
server address automatically.7. Otherwise, Choose Use the following IP address and
Use the following DNS sever address.
Use the following IP address: Select this when the fixed IP address is set.
zIP address: Enter the IP address of the device.
zSubnet mask: Enter the subnet mask.
zDefault gateway: Enter the default gateway.
Use the following DNS server address: Select this when you set the fixed address
as the IP address of DNS server.
zPrimary DNS server: Enter the IP address of the primary DNS server.
zSecondary DNS server: Enter the IP address of the secondary DNS server, if
necessary.

15
5.1 Mobile Phone Viewing
5.1.1 3G Mobile Phone Streaming Viewing
For 3G mobile phone viewing, type “ rtsp://<IP>:<PORT>/video.3gp ” into your 3G
Streaming Link. <IP> is the Public IP address of your IP camera; <PORT> is the RTSP port
of your IP camera (Default value is 554.) Example: rtsp://100.10.10.1:554/video.3gp
Note: You can also use RTSP clients (RealPlayer, VLC, QuickTime Player…etc.) to view
RTSP streaming, just type in “rtsp://<IP>:<PORT>/video.3gp” as the Player URL
5.1.2 2.5G Mobile Phone WAP Viewing
For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml” into your 2.5G WAP Browser.
<IP> is the Public IP address of your IP camera.
5.1.3 2.5G Mobile Phone Browser Viewing
For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml ” into your 2.5G Web Browser.
<IP> is the Public IP address of your IP camera.
5 5. Operating IP Camera
via Mobile Phone

16
5.2 Using IP Camera via iPhone
You can access to your IP camera via your iPhone. Please follow the setting process below.
Then you can use the Web UI via iPhone.
A. Select Safari function B. Type IP address in your web link.
C. Type name and password.
Default value is admin / airlive.
Then click Login In
D. The Web User Interface and
live image will show up in the
middle of screen.
Note: The image is continuous snapshots, not video. Thus, live image can’t be
recorded here.

17
Please follow the following steps to set up the Messenger function.
A. Download free MSN software and create a new MSN account (Camera at home) for
Microsoft Live Messenger.
B. Go to “Setting→Basic→Network→Messenger,” set the Messenger to “ON” . Then, fill out
Login Account and Password (Camera at home).
C. The Alias will be shown as the nickname on the contact list when you login with the
messenger account that be added to the Allow list.
D. If your router has firewall function, you have to set the Port Range on this setting page in
6 6. MSN Messenger