AirLive Air3GII User manual

Q: Firmware upgrading failed, how to recover Air3GII?
A: Please refer the followings to upgrade firmware again
1 Unplug the power of your device
2 Hold the hardware reset button while plugging the power
After 10seconds, the Mobile LED will flash very fast, please release the reset button

3 Set your PC's IP address to 192 168 123 100 Connect the device’s LAN port to your PC
4 Open your web browser (Recommended browser: IE), then type "192 168 123 254"
You will see the emergency function page where you can upload your device’s
firmware

5 The procedure will take about 3 minutes to upgrade firmware
If it succeeds , the message will show 3 seconds
6 Please unplug and re-plug the power of your device manually
7 Please wait a while until it boots up
Then press the hardware reset button over 10 seconds to restore it to factory default
setting After resetting, the device’s IP is 192 168 1 254
8 Set your PC’s IP address to “Obtain an IP address Automatically” The device will provide
your PC a valid IP address

9 Open your web browser, and then type "192 168 1 254"
You will get into the web management