AirLive AIRMAX2 User manual

How to Configure AirMax2 as Universal Repeater
1. Connect your PC directly to the LAN port on the DC Injector of AirMax2
2. Set your PC’s IP address manually to 192.168.1.100 (or other address in
the same subnet)
3. Enter AirMax2’s IP address (default is 192.168.1.1) on the web browser.
The default username is “admin” and password is “airlive”.

4. Change to Universal Repeater Mode. AirMax2 will reboot to make it
effective. Please wait about 2 minites.
5. Configure Network SSID, Channel, Security and SSID of Extended
Interface.
Network ID: The SSID would be seen by wireless network card that would
like to connect to AirMax2.
Security: The remoteAccess Point Security. The wireless network should
enter the security while connecting to AirMax2.
Channel: The RemoteAccess Point Channel.
SSID of Extended Interface: The remoteAccess Point SSID.

6. Click “Apply Change” to Save and reboot to make it effective. Please wait
about two minutes. After reboot, the AirMax2 will connect to remote
Access Point automatically and provide wireless signal for connection.
Please note, if AirMax2 does not connect to remote Access Point, the AirMax2
would not be seen by the wireless network card.