AIS Divi User manual

Revised 02.19.10 www.AIS-INC.com 1
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Indentify Non-powered panels
and separate from Powered
panels. Non-powered panel
shown at left..
Powered panel shown at left
has powerway mounted at
factory. Also separate panels
by surface type, width and
height.
Polypropylene hinges are used
to connect panels together.

Revised 02.19.10 www.AIS-INC.com 2
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Hinges are precut in the
factory. Every panel ships
with correct amount and sizes
of hinges. Hinges are cut to
12 7/8, 20 7/8, 36 7/8, and 52
7/8. See Chart below for the
appropriate sized hinges to
use for each panel connection
With panel glides turned in all
the way to the lowest point,
align two panels as shown.
Note that each panel has a
pair of alignment plates that
interlock when abutted, locking
panels together vertically.

Revised 02.19.10 www.AIS-INC.com 3
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Panels interlocked prior to
hinge installation.
Push panels together at the
top. Level panels such that
side rails remain parallel and
flush. This will make hinge
installation easier. Note hinge
channels formed when panels
are aligned.
Slide 20 7/8 inch long hinge
down into hinge channels.

Revised 02.19.10 www.AIS-INC.com 4
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Use non-marring mallet to tap
hinge down fully.
Use flat head screwdriver
inserted into hinge channel at
an angle to push first hinge
down below top of side rail.
Insert second hinge and tap
down both hinges with mallet.

Revised 02.19.10 www.AIS-INC.com 5
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
In certain situations on tall
panels it may be necessary to
tap first hinge down to bottom
before tapping down second
hinge. Use flat head
screwdriver inserted at angle
into hinge channel and tap
shaft of screwdriver gently to
slide hinge down to bottom of
panel.
IMPORTANT – Hinges MUST
be fully engaged and seated
directly on top of alignment
plate at base of panel. No
gaps can exist between plate
and hinge.
IMPORTANT – Hinge must be
recessed between ½ and ¼
inches from top of side rail to
leave space for hanger frame
topcap. If PANEL
CONNECTION is a 180
degree, straight line condition,
insert another complete set of
hinges on opposite side of
panels.