1ST PASS
1. Insert ONE 8.5 x 11” Sheet into the 1st Pass Tray.
CAUTION: Inserting more than one sheet may
damage unit and void warranty.
Tips:
- If paper is too tight or too loose on the 1st Pass
Paper Feed Tray, turn the 1st Pass Adjustable Side
Margin Knob as needed to fit the sheet properly in the
1st Pass Tray.
- The center point of your sheet should line up with
Arrow Mark 1. If needed, adjust the 1st Pass Adjust-
able Paper Feed Knob to move the 1st Pass Paper
Feed Tray left or right to fine-tune alignment.
2ND PASS
2. Insert ONE of the cut sheets from 1st Pass
into the 2nd Pass Tray. CAUTION: Inserting
more than one sheet may damage unit and void
warranty.
3. Align sheet to the 2nd Pass Side Margin Stop
on the right.
Tip:
- Arrow Mark 2 should line up with the borderline
between the 3rd and 4th cards. If needed, adjust
the 2nd Pass Side Margin Adjustable Knob.
1
32
4
Tips:
1. Contact your distributor for the Cardmac Bleed Template.
2. Keep a clean working area by lifting the Easy-View Window and clearing any debris
from the blades. DO NOT TOUCH BLADES.
Arrow Mark 1
Arrow Mark 2
(located under back window) 6
Adjust Side Margin Knob If Needed
4. Press and Hold the two Push Marks with
both thumbs evenly until the sheet passes com-
pletely through the blades.
