Alarmcom Skybell HD Edition Technical manual

Alarm.com Wi-Fi Doorbell Camera
Skybell® HD Edition
Questions?
Contact Alarm.com Dealer Support at [email protected] or find your
local number at the following website: www.alarm.com/dealersupport
US and Canada: 1.866.834.0470 | MX: 001.855.300.9897
• Before you begin, go through the Pre-Installation Checklist at:
alarm.com/doorbellinfo
• Install the doorbell camera hardware, replacing the existing
doorbell. Detailed instructions are available at:
alarm.com/doorbellinfo
• Download the Alarm.com Customer App from the App Store
or Google Play and log in using customer credentials.
(Doorbells installed using the Skybell App will not work
with Alarm.com.)
• Go to the Doorbell Camera section of the app and follow the
guided setup to Add a New Device. (The customer account
must have a service plan with the Doorbell Camera enabled.)

© 2016 Alarm.com
RED / BLUE – alternating flash ..............
YELLOW – solid (not flashing) ................
GREEN – rapid strobe flash ....................
RED/GREEN – alternating flash ............
ORANGE – rapid double-flash ................
BLUE/GREEN – alternating flash ..........
GREEN – solid (or user selected color)....
WHITE – solid ............................................
BLUE – rapid strobe flash ........................
YELLOW – rapid strobe flash ..................
RED – rapid double-flash ........................
BLUE/YELLOW – alternating flash ........
Doorbell Camera is charging
System booting
Entering access point mode, release and wait
for green/red LED before syncing the camera
(about one minute)
Wi-Fi access point mode (AP Mode)
No Wi-Fi, or lost Wi-Fi connection
Connected to Wi-Fi, waiting for
server connection
Ready
‘In-Call’ mode
Power Cycle – HOLD button until LED rapidly
flashes blue (about two minutes)
Factory Reset – HOLD button until LED
rapidly flashes yellow (about two minutes)
Power Supply Issue
(see alarm.com/doorbellinfo)
Firmware update in-progress
Alarm.com Wi-Fi Doorbell Camera
LED Reference Guide