ALCO AL-66049 User manual

ReadThisFirst!
1. Locate the plastic bag which contains the assembly parts.
2. Do not attempt to install nor assemble a toilet support without first
reading the instructions!
3. Find the two Parts Sheets “A & B” and check contents. Call us if found
lacking.
4. Read the Extensions Assembly pages. Vertical leg extensions are needed
for Standard & ADAheights.
5. Find and use the toilet Profile Page to identify your toilet. Use the number
in the center of your choice.
6. Find the Assembly Page (s) corresponding to your toilet number.
7. Assemble your support by exchanging the necessary pieces using the proper
numbered instructions.
8. After assembling your support, find and use the Mounting Instructions.
Callifyouhaveanyproblemsorsuggestions!
AL-66049
Universal Toilet Support

Read All of This!

 
 

 3  3 

  
DO NOT ATTEMPT TO POUND THE THREADED INSERT INTO THE EXTENSION OR PERMANENT LEG
WHILE IT IS MOUNTED TO THE TOILET!!

 
 

  
 
 
   

  
 
Extension Assembly Instctions
[email protected] | 800.323.4282 | www.alcosales.com
[email protected] | 800.323.4282 | www.alcosales.com


 
I/
 
 3  3  4 

 
@ ®



 
0

I



I
SK29

SK4
 SK24
®

-o
RR
 u
MB
OB
VE
ER

&
REMPLV
FOR
·l
UGE
\�- _  _
SKlO
Pas Page: A

0
0
 -82787

I

(  ) 3  3  4 
0
0
0 






Parts Page: B

MOUNTINGINSTRUCTIONS
AL-66049
•Take assembled Toilet Support and loosen the bolts which hold the
“Hanger” and “S-Bar” together leaving them loosely connected. (See
Figure #2) This is the most important advice that is often overlooked but
will make the assembly much easier!
•Attach the Support to the Toilet by first removing only two cap nuts and
placing the Hanger with the loosely attached S-Bar over the now exposed
Carrier Bolts, then replace the removed Cap Nuts securing the Hanger to
the Toilet. WARNING! BREACKAGE OF VITREOUS CHINA
MAY OCCUR IF CAP NUTS ARE OVER TIGHTENED! DO
NOT OVER TIGHTEN CAP NUTS! If Carrier Bolts are too short
then use the Extended Cap Nuts provided in this package. Again, please
adhere to the above warning about tightening the Cap Nuts.
•Center the Support as you now tighten the two bolts which connect the
Hanger and the S-Bar together. For proper Bumper positioning (See Profile
Page), tightening these bolts will raise the rubber tightly up against the
bottom of the bowl.
•Adjust the Non-Skid Foot so that the bottom of the foot pad is 3/8” off the
floor, allowing the entire spring loaded leg to swing freely back towards the
wall then forward to its original position. Once satisfied with the
adjustment, tighten the lock nut above the foot to keep it set in place.
Any Questions or Comments, Contact us at:
[email protected]
OR
[phone]
[email protected] | 800.323.4282 | www.alcosales.com

0
0
>------r- _______ ___...._ -
!
l
--:\
SKlO
...,
g
I
Profile #6 Parts Assembly
[email protected] | 800.323.4282 | www.alcosales.com AL-66049
Universal Toilet Support