Alen BreatheSmart 75i User manual

USER MANUAL
Alen BreatheSmart 75i
We would love to hear from you. If you have any questions,
please contact us at 1 [phone].

TABLE OF CONTENTS
Using Your
Operating Your Unit
Know Your
Care & Maintenance
Replacing The Filter
Why You Should Replace Your Filter
Alen’s Filter Plans
How To Replace The Filter
Troubleshooting Tips
Warranty Information 10
The 8 hr TWA Ozone for this product is 0.001 ppmv when tested
in a 30 m3 chamber. Refer to safety instructions in manual for
more information.

3
www.alen.com 1-800-630-2396
AIR PURIFIER SAFETY
This manual provides important safety messages regarding your electrical home appliance.
Always read, follow, and, save all safety directions.
Location Requirements
• Use a level surface at least 6" (15.2cm) from heat sources such as ranges, dryers, or heaters.
•Do not block air vent openings.
•
•a bed or sofa.
•Do not use in a window.
•Do not use next to a source of heat such as a range, heater, or dryer.
•Do not use near any source of water such as a sink, bath, shower, or swimming pool.
• Operate indoors only.
Electrical and Safety Requirements
Failure to follow these instructions can result in property damage, injury, or death.
• Do not connect unit to any electrical socket that is damaged.
•
• Do not insert or pull out plug with wet hands, it may cause electric shock.
• Do not use an adapter. Do not use an extension cord.
• Use only in the proper electrical socket type. Socket type (voltage & hertz) can be found on
the unit’s back panel label. Incorrect socket use can damage/destroy the unit.
• Do not exceed the rating of the power outlet or connection device. May cause electric
• Never try to take apart or repair the unit by yourself.
• Disconnect power immediately if you notice strange sounds, smells, or smoke.
•
• .
•
• Do not drop the unit, as this can result in damage.
• Do not place heavy objects on the power cord and be sure the cord is not compressed
•
• WARNING! To reduce the risk of electric shock, this equipment has a polarized plug
.

4
www.alen.com 1-800-630-2396
USING YOUR AIR PURIFIER
Operating Your Unit:
1.
2.
lights will light up. To turn off the lights on your unit, touch the Power Button. To turn off
3. The Color Ring around the Power Button indicates the air quality being measured by
the particle sensor.
4. Press IONIZER to activate the ozone-safe ionizer. Activation of the ionizer enhances
your unit’s ability to remove airborne particles (similar to the way dust is attracted to a TV
screen). Press the ionizer button again to turn off.
5. FILTER life Indicator — There are three lights above the FILTER button: Green, Yellow
This is the ideal time to
6.
be reset to Green.
7.
twelve) before turning off.
PLEASE NOTE:
The BreatheSmart 75i has a capacitive touch panel. The buttons only operate with a
quick, light touch. Holding the buttons down will not activate the controls properly. A
chime will indicate that the control has registered your touch.
COLOR
Blue
Green
Orange
Red
Purple
MEANING
Very low level of airborne particles detected
Low level of airborne particles detected
Medium level of airborne particles detected

5
www.alen.com 1-800-630-2396
AUTO
IONIZER
Rating label
Wheels
Control panel
Side air intake
Handle for easy carrying
Two, four, and twelve
hour timer to control
air circulation.
Ozone-safe Ionizer,
On/Off.
fan speeds. Lights will
display selected speed.
Child lock, hold
for 3 seconds to
Lock/Unlock the
control panel.
•
• Touch for 5 secondsafter
green.
Touch to START
or STOP your
Automatic Mode sets
speed for optimal
performance.

6
www.alen.com 1-800-630-2396
KNOW YOUR AIR PURIFIER
fan speed like speed four (4) or Turbo (T), for at least two hours in order to clean the room’s air
or be set on Auto mode.
Features
• True HEPA filtration captures dust, allergens, and airborne pollutants
• 5 fan speeds with a two, four, and 12+ hour timer to control air circulation
• Filter change indicator light keeps replacements on schedule
• Simple and intuitive touch button controls
• Auto-off safety feature when front cover is removed
CARE & MAINTENANCE
Turn The Lights Off/On
To turn the lights off on your unit, touch the Power Button. The lights will go out but the unit
will not turn off. Touch any button to turn the lights back on, or touch the Power Button a
second time to turn the unit off completely.
Replacing The Filter
The Filter Indicator has 3 lights: Green, Yellow, and Red. The Green light will be illuminated for
Y
Y
by calling 1-800-630-2396. The Red light will be illuminated when it is time to replace the filter.
The filters used in Alen Air Purifiers are not designed to be washed, cleaned, or otherwise
-
maximize performance.
The screen layer of the filter, known as the Pre-Filter, captures large dust and hair.This layer
can be vacuumed periodically to maintain efficient operation of the unit.
Reset the Filter Indicator
to Green.
Cleaning Instruction: Control Panel
To avoid scratching the control panel, do not use abrasive/caustic cleaning solutions or scrub-
bing pads. With the unit unplugged, dampen a clean towel with soap and water to clean the
control panel, then dry gently with a soft cloth or paper towel. Glass cleaner (e.g. Windex) is
also OK. To avoid damaging electronic components **DO NOT allow liquid to seep into the unit.

7
www.alen.com 1-800-630-2396
Why You Should Replace Your Filter
•
•
• .
ALEN’S FILTER SUBSCRIPTION PLAN — Pure Air Made Simple
12 5
Savings —
Convenience — .
Superior Coverage —
.
How To Replace The Filter
Always unplug the unit when installing a filter.
Distinguish the front side from the back side of the filter. The front side has a screen
pre-filter and pull loop at the top.
Place the used filter in a plastic bag to prevent dust from re-entering the air.
1. With the unit standing upright,
intake vents with one or both
hands to release the magnets.
2. After pulling the cover out, lift it
away from the unit.
Save 10% over retail and get FREE SHIPPING on every filter.

8
www.alen.com 1-800-630-2396
3.
and down on the pull loop. Place the
dust from re-entering the air.
4.
bag, insert the bottom. Firmly push
into place.
5. Insert the bottom hooks
then the upper part of the
cover will snap into place.
WARNING! RISK OF ELECTRIC SHOCK - To reduce risk of electric shock, do not perform
any servicing other than that contained in the operating instructions.

9
www.alen.com 1-800-630-2396
TROUBLESHOOTING TIPS
Unit will not power on.
yellow lights are still illuminated.
seconds while the unit is ON. The light above the FILTER button should reset to green.
Please refer to the rating label on the back of the unit. Here you will nd your unit’s voltage,
hertz, amps and outlet requirements.
Can I clean the filter?
The screen layer of the filter, known as the Pre-Filter, captures large dust and hair. This layer
can be vacuumed to maintain efficient operation of the unit. No other layers or parts of the
filter can be washed, cleaned, or otherwise reused. Please replace the filter regularly to
maintain optimal performance.
I have an issue not listed in this manual.
Please visit www.alen.com and send us a message or call 1-800-630-2396 during business
hours. A customer service representative will respond to your inquiry in a timely manner.
What information do I need when I contact customer service for warranty?
Please refer to the rating label on the back of the unit. This rating label has your unit’s serial
number and other important information we need to assist you.
Check that the power cord is properly seated into the back of the purifier. Firmly push top
of filter frame up and in until it clicks. Last, check that front panel is on properly (fit snugly
to the purifier).

10
www.alen.com 1-800-630-2396
WARRANTY AND EXTENDED COVERAGE
Please visit https://alen.com/foreverguarantee for all warranty information. For any
questions, please contact customer service by calling 1-800-630-2396 or email
[email protected]
Alen Corporation
9200 Waterford Center Blvd. Suite 600
Austin, TX. 78758
REGULATORY INFORMATION
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC/ISED RF Exposure Information: This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.

11
www.alen.com 1-800-630-2396
Canada
This Class B digital apparatus complies with Canadian ICES-003.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions: (1) This device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of this device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
FCC/ISED Informations sur l’exposition RF: Ce matériel doit être installé et exploité à une
distance minimale de 20 cm entre le radiateur et votre corps.

Copyright © 2021 Alen Corp. All Rights Reserved.
BreatheSmart 75i November-16-2021
202112_02