Alinco DR-112E User manual

er
The DR-112T/112E provide a powerful
45Watts of RF Output with HI/LO
powerswitch.
ht.
140(W)x40(H)x170(W)mm (5-1/2”x
2”x6-33/4”) at 1 .lKgs(2.42 lbs)
14 i
Function
nels.
The unit contains 14 fully program-
mable Memory Channels. Each
channel stores operating frequency,
Standard offset and other useful
information.
A new color LCD.
L
tin
s.
for ease of operation 5, 10, 12.5, 15,
20 and 25 KHz.
nin
.
(a) VFO -Scanning of the entire band.
(b) Memory -Scanning of selected
memories.
(c) Programmed Band-Scanning of a
selected segment of the band.
(d) Priority Scanning-Allows selection
of a frequency, in VFO or Memory,
to serve as a priority frequency.
tion.
allows for programmable encode/
decode sub-audible tones(DR-112T’)
or a 1,750Hz tone call function(DR-
112E).
icrophone
The standard microphone offers:
(A) UP/DOWN buttons for ease of
frequency/Memory selection.
(6) An LED “ON AIR” indicator and
“LOCK” switch to enable/disable
microphone function(DR-112E )
(C) DTMF Encoder built-in.(DR-112T)
c
upstanding
Features:
Function Lock Key
Reverse Key-Inverts TX-RX
Memory Skip
Odd Offset
Multiple Standard Offsets
Other too numerous list.
ccessories supplied
as standard:
Hand Microphone(Condencer type)
a. 16 button DTMF Microphone(DR-
112T) b. Hand Microphone(DR-112
E)
Mobile Mounting Bracket
Mounting Hardware
D.C. power Cable

@General
Frequency Coverage
~~~~~~~~~~~~~~~~~144.00-147.995Mhz.(U.S. Version)
144.00-1459875Mhz.(Europe Version)
Frequency Resolution ............... 5, 10, 12.5, 15, 20 and 25Khz.
Antenna Impedance
................. .50 ohms unbalanced
Power Supply requirement ......... 13.8 Volts D.C.
Current Drain at 13.8V.. ........... ..Receivin g
Squelched:Does not exeed 500mA
Transmitting
High:45W approx 9.5A
Low: 5W approx.4A
Dimension ..............................
.14Omm(W) x 4Omm(H) x17Omm(D)
(5-l/2”) x (2”) x (6- 3/4”)
Weight.. .................................. l,lKgs.(2.42Lbs,)
l Transmitter
Output power
........................... High:&W&s
Low :Approx. 5Watts
Emission Mode .......................
.16F3
Modulation System .................
..Variabl e Reactance F.M.
Max. Frequency Deviation ......... $5Khz
Spurious Emission
....................Mor e than 60dB below Carrier
Microphone ............................. Electret Condenser Microphone
Operating Mode.. ..................... Simplex
Duplex: f 6OOKhz from receive frequency
and odd offsets programmable
DTMF Encoder ....................... ..Built_in(DR-IlOT)
aReceiver
Receiving System ................... ..Superhetrodyne.
dual conversion
Modulation acceptance .............16F 3
Intermediate frequency ..............ls t 10.7Mhz 2nd 455Khz
Sensitivity.. ........................... ..12d B SINAD less than 0.16uV
Selectivity ............................... More than
k6Khz at -6dB
Audio Power Output .................. More than
15Watts(8ohms -10% Distortion)
Speaker Impedance
................. .8 o,,,-,,s
Note:Specifications are subject to change without notice.
Specifications are guaranteed for amateur band only.
(Frequency 130MHz-169.995 MHz can be modified for commercial use.)
Nlugged Die-Cast Chassis k
Option
Tone Squeltch
Unit EJ-3U
n Front Panel
n LCD Panel
aMain Dial
@LCD Panel
@Volume Control
8 Squelch Control
@H/L Switch
Power Switch
Function/Memory Write Key
MHz(Band) Key
VFO/M/Chann.el Step Key
@I Reverse/Lock Key
aShift Key
@Sub Tone/Beep Key
Priority Key
@Scan/Memory Skip Key
@Call Channel/Call Channel Write Key
(DR-IlOE: Tone Burst Key)
@t Microphone Terminal
(B Reverse Indication
@I Offset Indication
@I Tone Encoder Indication
@ Tone Decorder(Tone Squelch)lndication
@ Priority Indication
@Call Channel Indication
@ Frequency Indication
@ Decimal Readout Point
@Busy Indication
@S/RF Meter Indication
@On Air Indication
Memory Indication
($9 Memory Channel Indication
Authorized Dealer:
Head Office: “TWIN 21” MID Tower Bulldmg 23F, l-61, P-Chome, Shiroml,
Chuo-ku, Osaka No.540, Japan
P
Factory: l-i-1, Mishimae, Takatsuki, Osaka No.569, Japan
( AL/NC0
ELECTRONICS INC.
L
438 Amapola Avenue, Unit130, Torranck, CA 90501, U.S.A.