AlkaWay UltraStream 420080 Instruction Manual

Version 3 - Dec 18 1
To connect an UltraStream on your bench top to a dedicated tap
Included is everything you need to install your UltraStream on its own dedicated tap.
Position and drill the tap hole
Locate a position on the bench top or sink with enough room to ensure the tap can be turn on and off
and make sure you can access the hole from under the sink.
1. Place tape over the spot where you are to drill to allow the drill to stay centred,
2. Drill a hole between 12.7mm - 25mm (1/2” to 1”inch) hole in sink top. Drilling in stone will
require an expert,
3. Remove burrs and any sharp edges around the hole before installing the tap.
Installing the tap
1. Remove brass nut, washer (unscrew) and plastic black disc from the tap assembly,
2. Feed the tap tube through the hole in the sink and position the tap,
3. Feed the black plastic disc, brass washer and nut back onto the tube. Firmly tighten the nut into
place.

Version 3 - Dec 18 2
Cold water connection
1. Hand tighten the cold-water connector
pieces together.
2. Turn off the cold-water supply. Using the
shut-off valve below the sink or at the
house water mains.
3. After shutting off the water open the
kitchen faucet draining the remaining
water out of the line. Turn on a (lower)
garden tap to drain the water line.
4. Place a container below the sink, under
the shut off valve and disconnect the cold-
water line.
5. Install the cold-water connector (Make
sure it’s turned OFF).
6. Reconnect the cold-water line.
Tube connections
Connect the tube into position as per the
Schematic (refer to page 1).
Above the sink: use the supplied ¼” tube
connects the tap to the UltraStream. The
UltraStream connection is inside the base.
Remove the base cover to access connection.
Under the sink: The tube from under the tap
connects to the cold-water connection.
Turn blue tap on the colder water connector
check for leaks.
Refer to the UltraStream manual to complete the UltraStream installation.