Allied Telesis AT-2971T User manual

Allied Telesis www.alliedtelesis.com
Datasheet | Network Interface Cards
AT-2971T
Gigabit Ethernet Copper PCI Extended Server Interface Card
A
T-2971T
PCI-x 64-bit copper Gigabit interface card
High Performance
Ahigh performance interface card with a 32-bit
or 64-bit (33/66/1000/133 Mhz) bus, line speed
and jumbo frames support, Allied Telesis’
AT-2971T supports the calculation of TCP, UDP
and IP checksums through the hardware
platform without time loss by the MAC
controller for both transmission and receiving
paths—a capability that leads to improvements
on overall system performance.To reduce the
load on the CPU, Allied Telesis’ AT-2971T uses
interrupt moderation to group the huge
amounts of interrupts caused by small packets
transferred at Gigabit speed, enabling the
handling of several data packets per interrupt.
High Reliability
The AT-2971T Gigabit Ethernet interface card
comes with a variety of reliability features that
maintain the longest-possible connection
through link aggregation, redundant switch
failover and PCI hot plug.The on-board sensors
and driver functions monitor the health of
interface cards and their ports, enabling
proactivenetworkmanagement.
Comprehensive Software Support
The AT-2971T interface cards feature a set of
software programs that assist you with your
network set-up and configuration.The offline
user diagnostic program provides system
administratorsand engineerswith a tool to
analyze Network Interface Cards and check
specific data.The network control program for
Windows 2K,Windows XP and Windows Vista
Server 2003 allows you to easily control and
configure all your AT-2971T interface cards.
Virtual Cable Tester™ (VCT)
The VCT program detects and reports
potential cabling issues such as cable opens,
cable shorts or any impedance mismatches in
the cable. It can also accurately locate the
distance to the cabling fault within a tolerance
of one meter, helping you to quickly identify
failing mechanisms and isolate the source of
problems.
Key Features
Management Software
•Virtual cable tester
•VLAN support
•Link aggregation LACP
•Failover
Advance Properties
•Jumbo frames
•Checksum offloading
•Adaptiveinterrupts
•Sensor support
•PCI-x (PCI Extended) 64-bit
•Windows Vista
•IEEE 802.1x flow control
•IEEE 802.1p-based traffic prioritization
•TCP segmentation (large send)
•PXE 2.1 remote root support
•Wake-on-LAN (WoL)
•Low-profile and standard height brackets
included
•Microsoft certified drivers
•RoHS compliant
•Dynamic interrupt moderation

USA Headquarters |19800 North Creek Parkway |Suite 200 |Bothell |WA 98011 |USA |T: [phone] |F: [phone]
European Headquarters |Via Motta 24 |6830 Chiasso |Switzerland |T: +41 91 69769.00 |F: +41 91 69769.11
Asia-Pacific Headquarters |11 Tai Seng Link |Singapore |534182 |T: [phone] |F: [phone]
www.alliedtelesis.com
©2007 AlliedTelesis Inc. All rights reserved. Information in this document is subject to change without notice. All company names, logos, and product designs that are trademarks or registered trademarks are the property of their respective owners. 617-000233 Rev C
AT-2971T |Gigabit Ethernet Copper PCI Extended Server Interface Card
Specifications
Management Features
WMI
ACPI 2.0/wOI
PXE 2.1 Boot ROM
Bus Type
PCI-x 64-bit
Ethernet Standards
IEEE 802.1p Quality of Service
IEEE 802.1Q VLANs
IEEE 802.2 LLC
IEEE 802.3ac MAC
IEEE 802.3 10 Ethernet
IEEE 802.3u Fast Ethernet
IEEE 802.3ab Gigabit standard
Drivers
Supported
Vista
Vista 64-bit
Windows XP
Windows XP 64-bit
Windows 2003
Windows 2003 64-bit
Windows 2000
NDIS2
NetWare 6.x
Linux 2.4
Linux 2.6
Available
Solaris x86
Solaris Sparc 32-bit
Solaris Sparc 64-bit
Free BSD
AIX
NetWare 5.x
Compliance
RoHS
cUL
UL
FCC/EN55022 Class B
TUV
EN55024
CE
C-TICK
VCCI
Connectors
RJ-45
Environmental Specifications
Operating temperature 0°C to 50°C
Storage temperature -25°C to 70°C
Relative humidity 5% to 90% non-condensing
Power
Power consumption 3 Watts (max)
Signaling voltage 3.3/5V
Status Indicators
LED 4 ports
10 ON 10Mbps link up
OFF 10Mbps link down
100 ON 100Mbps link up
OFF 100Mbps link down
1000 ON 1000Mbps link up
OFF 1000Mbps link down
ACT ON Receiving/transmitting
OFF Not receiving/
not transmitting
Physical Characteristics
Dimensions 16.8cm x 5.4cm
(W x H) (6.7”) x (2.1”)
Weight 72g
Ships with standard bracket attached to interface card.
Low-profile bracket is included in packaging.
Network Type
1000T
Network Speed
Auto-negotiation
100 full-duplex
100 half-duplex
10 full-duplex
10 half-duplex
Network Controller
Marvell 88E8022
Ordering Information
AT-2971T-yyy
PCI-x 64-bit copper Gigabit interface card
Where yyy = 001 for single pack
020 for 20-pack
901 for single pack, Federal and
Government
920 for 20-pack, Federal and Government
Ships with standard bracket attached to interface card.
Low-profile bracket is included in packaging.