Allnet ALL95100 User manual

ALL95100
Gigabit CAT 6 Surge Arrester
For 10/100/1000Mbit Ethernet + PoE
Quick Installation Guide

© ALLNET GmbH Munich 2013 - All rights reserved.
Safety instructions for the installation
- ALL95100 is just for network interface cards, hubs, switches and
other network equipment.
- Never install the ALL95100 during a electric storm!
- Only for installation in cool, dry rooms.
- Power off all devices which should be prevented before
installation.
- ALL95100 must be connected to ground.
- To prevent electrical shock while installing the ground wire to the
electrical power outlet ground, disconnect electricity to the outlet.
From the electrical panel, switch off the appropriate circuit breaker
or remove the fuse.

© ALLNET GmbH Munich 2013 - All rights reserved.
Note: Due to the bi-directional structure of the ALL95100 Surge arresters
the input and output side is arbitrary exchangeable.
Installation
1. Power off the device which should be prevented.
2. Disconnect the network cable from the device which should be
prevented.
3. Connect this network cable with one port of the ALL95100.
4. Connect one end of another network cable with the second port
of the ALL95100.
5. Connect the other end of this network cable to the device which
should be prevented.
6. Connect the yellow-green ground wire with an external
grounding conductor.
ALL95100
Grounding conductor
Network cable
Network cable

© ALLNET GmbH Munich 2013 - All rights reserved.
Technical specifications
Peak Surge Current: 10kA (8/20µs), 100A (10/1000µs)
Breakover Voltage: 90VDC ±20% (Pair to Earth)
<450V (bei 100V/µs)
<600V (bei 1kV/µs)
Diff. Clamping: <15V, <5ns, 30Apk (Pair wire to wire)
Diff. Capacity: <4.0pF
PoE-able: IEEE802.3af, at, LTPoE++ up to 90W
Operating Temperature: -15°C to 65°C
ESD: IEC 61000-4-2 class 4 (10kV CD)
Relative Humidity: 95%, non-condensing
Lines Protected: (Pins) 1 - 8 (on 8 pinned modular jack)
Standard Compliance: IEEE 802.3, CAT 5, 6
Please note: We recommend that the protective conductor should
be installed by a qualified electrician.

© ALLNET GmbH Munich 2013 - All rights reserved.
CE-Declaration of Conformity
For the following equipment: Germering, 3rd of May, 2013
Gigabit CAT 6 Surge Arrester
ALL95100
The safety advice in the documentation accompanying the products
shall be obeyed. The conformity to the above directive is indicated by
the CE sign on the device.
The Allnet ALL95100 conforms to the Council Directives of 2004/108/EC.
This equipment meets the following conformance standards:
IEC61000-4-6:2009
IEC61000-4-8:2010, IEC61000-4-11:2004
IEC60950-1:2006+A11:2009+A1:2010
This equipment is intended to be operated in all countries.
This declaration is made by
ALLNET Computersysteme GmbH
Maistraße 2
82110 Germering
Germany
Germering, 03.05.2013