Make the motor at learning state (refer to motor’s user
manual), press ’s UP and DOWN buttons simultaneouslyremote
once, then short press STOP button once, the motor vibrates,
the is paired to the motor.remote
Short press the Channel Switch
Button to select a channel (from 1
to 4), once selected, the
corresponding light will shine.
Press UP and DOWN buttons
simultaneously once.
Then short press the STOP
button, now the code learning
of the selected channel is
successful. Other channels to
learn code in the same way.
4 channel remote
single-channel remote
Example: RE602 series could set four Channels, each channel with corresponding button and light.
a) During Sleep Mode (all lights are off), press any one switch button once, could check
which channel have been set (corresponding light will shine).
b During channel checking (channel light are on), press the channel switch button again.)
If the channel hasn’t ever been set, it will be set now, if the channel have ever been set, it
will be deleted now and the corresponding light off.
WALL MOUNT RE601i-RE602i 2p
ALPHA SUPPORT PHONE (909) 307-2320
Instruction guide for RE series wall mount remotes601i - RE602i
3. CODE LEARNING
4. GROUP CONTROL
