Amart Furniture 72594 User manual

1
ASSEMBLY INSTRUCTION
ROMULUS - DRESSER WITH
MIRROR
ITEM CODE - 72594
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
for any assistance to assembly or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
for any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084
72594
1672mm
950mm
450mm
1020mm
970mm
40mm

2
BEFORE YOU START :
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product
2. Take care when lifting. Product should be assembled as near as possible to the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
PRE-ASSEMBLY PREPARATION
72594
ALLOW 20 MINUTES 1 PEOPLE REQUIRED
ADDITIONAL TOOLS REQUIRED
We recommend using
a screwdriver to put this item
together. Do not use a power
drill, use the Allen Key provided
to assemble this product. Doing
this will prevent damage to the
product caused by over
tightened bolts.
NOT PROVIDE

PARTS LIST
ABD C
BOLTS
M6x45: 08pcs
WASHER
Ø6xØ19x2: 08pcs
SPRING WASHER
Ø6xØ11x1.2: 08pcs
ALLEN KEY
M4X59: 1 pc
3
DRESSER1 1PC
2
3
MIRROR 1PC
MIRROR SUPPORT 2PCS
72594
1
3
2

4
Attach the mirror (2) To the dresser (1) by the mirror support (3)
with bolts (A), washer (B), spring washer (C) and using allen key (D).
ABD C
BOLTS
M6x45: 08pcs
WASHER
Ø6xØ19x2: 08pcs
SPRING WASHER
Ø6xØ11x1.2: 08pcs
ALLEN KEY
M4X59: 1 pc
A
D
B
C
72594
3
1
2

ASSEMBLY COMPLETE
572594

6
B. Wall Strap
Ø4 x 15mm 2 pcs
A. Mounting Plate
4 pcs
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the
Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall
anchors.
2. Attach the second Mounting Plate to the funiture frame with the Short Screws.
3. Move the funiture to its final position. Thread a Wall Strap through the both Mounting
Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture and that
the Wall Strap is snug.
WALL BACK SIDE
SAFETY BRACKETS INTRUCTIONS
HARDWARE
This furniture poses a tipping risk and as such must be secured to a wall using the provided
tipping kit.
C. Large Screw
Ø5 x 40mm 4 pcs Ø4 x 20mm 4 pcs
D. Small Screw
D
B
C
A
A
72594

772594