Amart Furniture 74555 User manual

Imported by Amart Furniture Pty Ltd, Brisbane QLD Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
74555
Page 1 of 4
ASSEMBLY INSTRUCTION
SANTO ANDRE DISPLAY CABINET
ITEM CODE - 74555
Imported by Amart Furniture Pty Ltd, Brisbane, QLD Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084.
380
900
1800

Page 2 of 4 74555

Page 3 of 4
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the
Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire
wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both Mounting
Plates and tighten until snug. Do not over tighten.
NOTE
·This product must be fixed to a wall.
·As wall materials vary, screws and wall fixings are not always included.
·Make sure fixings are attached to a wall stud.
·If mounting onto brick or masonry you will need to acquire wall anchors.
·Consult your local hardware specialist on what wall fixing is appropriate.
·Check for plumbing or electrical wiring behind wall surfaces before commencing.
Ensure the correct wall fixings are used. Failure to do so may result in personal injury or cause
property damage if the product topples over.
SAFETY BRACKETS INSTRUCTIONS
Small Screw x 2Large Screw x 2
Wall Strap x 1
Mounting Plate x 2
HARDWARE
74555

Page 4 of 4 74555