Amart Furniture NIARA 75438 User manual

NIARA 3 SEATER
ITEM CODE - 75438
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please
phone Amart Furniture, Customer Service Free call 1800 351 084
PAGE 1 OF 5 75438
ASSEMBLY INSTRUCTION
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
880 MM
2170 MM
965 MM

BEFORE YOU START…
1. CHOOSE A CLEAN, LEVEL, SPACIOUS ASSEMBLY AREA. AVOID HARD SURFACES THAT MAY DAMAGE
THE PRODUCT.
2. TAKE CARE WHEN LIFTING. PRODUCT SHOULD BE ASSEMBLED AS NEAR AS POSSIBLE TO THE POINT OF USE.
3. CHECK AND ENSURE THAT YOU HAVE ALL THE REQUIRED CONTENTS FOR COMPLETE ASSEMBLY.
4. ALWAYS READ THE ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE BEGINNING ASSEMBLY.
5. THE PACKAGING AND CONTENTS CAN BE CHOKING HAZARDS, THEREFORE KEEP OUT OF REACH OF
SMALL CHIDREN AT ALL TIMES.
6. DO NOT OVER TIGHTEN THE SCREWS AND BOLTS AS THIS MAY DAMAGE THE THREADS.
PAGE 2 OF 5 75438
PRE-ASSEMBLY PREPARATION

PLEASE TAKE NOTE: PIECES REQUIRED FOR ASSEMBLY ARE LOCATED INSIDE THE DUST COVER UNDERNEATH
SOFA
PAGE 3 OF 5 75438
PARTS LIST

DETAILS (i) - Align base plate of each leg (A) with the pre-threaded holes in the undersides of the sofa as shown in the
below diagram. Insert bolt (B) through washers (C)(D) and tighten by turning clockwise using allen key (G).
DETAILS (ii) - Align plastic washer (F) with the pre-threaded holes in the undersides of the sofa as shown in the below
diagram. Insert support leg (E) and tighten by turning clockwise using hand.
ASSEMBLY COMPLETED
PAGE 4 OF 5 75438
IMPORTANT: PLEASE ENSURE LEGS ARE TIGHTENED SECURELY BEFORE USE!
WARNING - Do not drag lounge on any surface due to timber base, must be lifted.
Two Person Lift Recommended
Step 1

LEATHER CARE (FRAME)
WHEN NECESSARY BRUSH OR VACUUM AWAY DUST AND GRIT.
WIPE OVER WITH A SOFT, CLEAN,COLOURFAST CLOTH.
FOR SPOTS AND SPILLS:
∙ WIPE EXCESS LIQUID UP IMMEDIATELY WITH AN ABSORBENT
CLOTH OR SPONGE
FOR OVERALL CLEANING:
∙ WE RECOMMEND CLEANING EVERY 3-4 MONTHS WITH LEATHER
CLEANER FOLLOWED BY APPLICATIONS OF LEATHER PROTECTOR
∙ ALWAYS FOLLOW DIRECTIONS ON PACKS
NOTES:
∙ ACCUMULATION OF PERSPIRATION AND BODY OILS ON ARM PADS,
HEADRESTS, ETC. MAY DAMAGE YOUR LEATHER. THESE AREAS MAY
REQUIRE MORE FREQUENT CLEANING.
∙ DO NOT EXPOSE LEATHER TO DIRECT SUNLIGHT, INTENSIVE HEAT,
WEATHER OR SOAK UNNECESSARILY. ALWAYS AVOID EXCESSIVE
HARD RUBBING.
∙ DO NOT DRY CLEAN OR MACHINE WASH.
∙ DO NOT USE SADDLE SOAP; DETERGENTS; SOLVENTS; ABRASIVES;
UNIDENTIFIED LEATHER CLEANERS; SUEDE CLEANERS OR ANY
PRODUCTS CONTAINING SILICON OR SOLVENTS.
PAGE 5 OF 5 75438
CARE AND MAINTENANCE