Amart Furniture LUCIEN 73622 User manual

INSERT LINE DRAWING IMAGE OF
PRODUCT INCLUDING DIMENSIONS
HEIGHT – WIDTH - DEPTH
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
LUCIEN DINING TABLE
ITEM CODE 73622
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
173622

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
273622

PARTS LIST
1
TABLE LEG
2
TABLE LEG
3
TABLE TOP
373622

STEP 1: Insert table Leg (1) to table leg (2), connect the joints at
the bottom of the legs.
Note: If the gap is too small at the top of legs (2), separate
carefully to fit.
STEP 2: Turn over the legs carefully,and Fasten table leg(1) to
table legs (2) with washer(B) and short screw(C) by Allen key(D).
473622

STEP 3:Place the table top (3) with its bottom facing up on a
soft covered surface. Place the table legs on the table top,
aligning the holes..
STEP 4: Attach Table legs(1)(2) to Table top(3) with washer(B)
and long screw(A) by Allen key(D).
573622

STEP 5: Turn the table over carefully,adjust the adustable leg
until the table is level.
ASSEMBLY IS COMPLETE
673622

773622
CARE AND MAINTENANCE
As our timber is supplied from sustainable forests there will be natural variations in surface
texture and grain like knots, mineral streaks and sap runs that may affect the finish. These
differences in character are not defects, but distinctions that make each piece of furniture
unique
Our furniture is built to last. Following these steps for basic care should protect your
investment for years to come
Dust frequently with a clean damp lint-free cloth. This will help remove abrasive build up
which can damage a finish over time
Do not place hot objects on any furniture surface. Always use a hot plate or placemat.
Laminate and lacquer finishes on table tops provide added scratch and heat resistance to
our furniture, but they can still be damaged without proper care
Avoid exposing your furniture to strong sunlight, heat outlet, open windows or dampness.
Prolonged exposure to direct sunlight can fade the finish of your furniture, while extreme
temperature and humidity changes can cause cracking or splitting
Do not expose your furniture to any liquids. Never allow water to sit on your furniture.
Alcohol, nail polish and perfume are also dangerous as they will dissolve the lacquer finish
on contact and may require professional repairs
•Do not allow plastic to come in direct contact with your furniture. Chemicals in the
plastic of placemats etc. may soften and mark the finish if left in contact with the
furniture for a period of timeFailure to follow this warning could result in injury