Amart Furniture SAN MARCO 51129 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLYINSTRUCTION
SANMARCO3SEATER
ITEMCODE51129
ImportedbyAmartFurniturePtyLtd,Qld,BrisbaneAustralia.
Foranyassistancewithassemblyorformissingpartspleasephone
Amart Furniture,CustomerServiceFreecall1800351084
151129
104cm
96cm
225cm

PRE‐ASSEMBLYPREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
15
251129
2
WARNING
•DoNotallowchildrentoplayonthismechanisedfurnitureor
operatethemechanism.Legrestfoldsdownonclosingsothat
achildcouldpossiblybeinjured.Alwaysleaveinanuprightand
closedposition.Keephandsandfeetclearofmechanism.Only
theoccupantshouldoperateit.

PARTSLIST
1 SPLITTRANSFORMERCABLE
2 TRANSFORMER
3 POWERCABLE
351129
1
1X 1
2
1X 2
3
1X 3
12
3
3

Step1: Locatepowerpackwhichisattachedtothepostatrear
baseofelectricseat.
Step2:Slidebackreceiversintosteelmechanismpostsinthe
baseofthefurniture,andthenpressbothsidesoftheeach
backfirmlyintoplacetoensureeverybackautomaticallylocks
inplace.
4 51129
slidereceiver
intopost
Mechanismpostat
rearofseat
Receiveratbottom
ofbackrest

Step3: Takeoutsplittransformercable,transformerand
powercablefrompowerpackandthenconnect.
Step4:Plugtransformer cablesintosocketsatbackofsofa.
551129
powercable
transformer
SafetyNote:Transformer
andcablesarenottobe
placedunderorwithinthe
reclinerstructure.
Splittransformercable
1
Splittransformercable 2
Transformer 3
Powercable
12
3

651129
ASSEMBLYISCOMPLETE
SAFETYNOTE:
PLEASEENSURETHATALLELECTRICALCORDSANDCABLESARECLEAR
OFTHEFRAMEANDMECHANISM. AFAILURETODOSOMAYSEVER
YOURPOWERCORDRESULTINGINSERIOUSINJURYORDEATH.

READ THESE INSTRUCTIONS THOROUGHLY BEFORE USE:
DANGER: TO REDUCE THE RISK OF ELECTRIC SHOCK:
Always unplug from electric outlet before cleaning.
WARNING: RISK OF INJURY
Keep children away from extended footrest and any moving parts.
CAUTION:
•Do not allow children to play on this electric recliner or operate the powered mechanism.
The leg rest folds when closing and could possibly cause injury to a child. Always leave the
recliner in an upright and closed position when not in use. Keep hands and feet clear of
mechanism. Only the occupant should operate it.
•Do ensure fully enter the normal sitting position before using of the recliner. Improper
sitting, such as sitting in the front of recliner may result in damage to bothmechanismand
motor drive bar.
POWER CORD SAFETY
WARNING: Unplug and remove power cord from wall when not in use and store out of reach
of children.
Take care when moving recliner that wall and transformer cords are not underthebaseor
they may get damaged.
‐NEVER OPERATE ELECTRIC RECLINER IF IT HAS A DAMAGED CORD OR PLUG.
WARNING: TO REDUCE RISK OF BURNS, FIRE, ELECTRIC SHOCK OR PERSONAL INJURY TO
PERSONS:
•Use only for its intended purpose
•Never press or activate control switch if you are not seated in recliner
•Only the occupant should activate the control switch
•Never operate with more than one person occupying seat
•Never sit or stand on the footrest
751129
YES NO

851129