Amart Furniture WINTON 72059 User manual

450mm
1125mm
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts, please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
WINTON TALL CHEST
ITEM CODE 72059
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts, please phone
Amart Furniture, Customer Service Free call 1800 351 084
ITEM CODE 72059
1
950mm

ITEM CODE 72059
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
2. Take care when lifting. Product should be assembled as near as possible to the
point of use.
3. Ensure that you have all the required contents for complete assembly.
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads.
PRE-ASSEMBLY PREPARATION
Power drill set to low speed setting before use.
2
X2
2 PEOPLE REQUIRED
ADDITIONAL TOOLS REQUIRED
ALLOW 5 MINUTES
12 1
2
3
4
5
6
7
8
9
10
11

ITEM CODE 72059
3
1. Attach one Mounting Plate to the wall with the Large Screws.
Make sure to attach the Mounting Plate into a stud. If mounting into brick
or masonry, you will need to acquire wall anchors.
2. Attach the Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to it's final position. Thread a Wall Strap through both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall
and furniture and that the Wall Strap is snug.
Wall
Back side
A. Tipping Kits
Long Screw 2pcs
ITEMS REQUIRED
1Short Screw 2pcs Mounting Plate 2pcs Wall Strap 1pc
Note: Tipping Kits are attached on the back panel.
WALL

ITEM CODE 72059
4
ASSEMBLY IS COMPLETE
WALL

ITEM CODE 72059
5
CARE AND MAINTENANCE
A multi-step finish is applied to all our furniture, but all wood comes
from nature. Because of this, there will be natural
variations in surface texture and grain like knots, mineral streaks and
sap runs that may affect the finish. These differences in character are
not defects, but distinctions that make each piece of furniture unique.
Our furniture is built to last. Following these steps for basic care
should protect your investment for years to come.
Dust frequently with a clean damp lint-free cloth. This will help
remove abrasive build up which can damage a finish over time.
Do not place hot objects on any furniture surface. Always use a hot
plate or placemat. Laminate and lacquer finishes on table tops
provide added scratch and heat resistance to our furniture, but they
can still be damaged without proper care.
Avoid exposing your furniture to strong sunlight, heat outlet, open
windows and dampness. Prolonged exposure to direct sunlight can
fade the finish of your furniture, while extreme temperature and
humidity changes can cause cracking or splitting.
Do not expose your furniture to any liquids. Never allow water to sit
on your furniture. Alcohol, nail polish and perfume are also dangerous
as they will dissolve the lacquer finish in contact and may require
professional repairs.
Do not allow plastic to come in direct contact with your furniture.
Chemicals in the plastic of placemats etc may soften and mark the
finish if left in contact with the furniture for a period of time.