AmazonBasics B08441B3D User manual

3-Color Temperature Level and 3-Section
Dimming LED Cabinet Light
Lampe de Placard à LED à 3Températures
de Couleur et Intensité Variable à 3Niveaux
Luz LED para Gabinetes con Atenuador
de 3Secciones y Nivel de Temperatura de
3Colores
B08441B3D3, B084411CGP, B084415L9D,
B084417MQQ

English . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Français . . . . . . . . . . . . . . . . . . . . . . . . . 24
Español . . . . . . . . . . . . . . . . . . . . . . . . . 42

3
A(x 1)
B(x 1)
Ø 1/4"
C(x 1)
5/8"

EN
4
IMPORTANT
SAFETY
INSTRUCTIONS
Read these instructions carefully and
retain them for future use. If this product
is passed to a third party, then these
instructions must be included.
When using electrical appliances, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock, and/or injury to
persons including the following:
CAUTION Risk of electric shock! To
prevent risk of electric shock, turn off the power
at the main circuit breaker box before installation.
WARNING Risk of fire! Most dwellings
built before 1985 have supply wiring rated up
to 140 °F (60 ºC). Consult a qualified electrician
before installation.

EN
5
CAUTION Risk of electric shock! This
product must be installed in accordance with
the applicable installation codes by a person
familiar with the construction and operation of
the product and the hazards involved. Consult
a qualified electrician to ensure correct branch
circuit conductor.
CAUTION Risk of fire! Do not install the
product on a radiant-heating ceiling.
CAUTION Risk of eye damage! LEDs
emit bright light. Avoid looking directly into the
light source for prolonged periods.
• This product is rated 120 VAC and must be
connected to a suitable power source.
• This product is not intended for recessed
installation in ceilings, or soffits.
• Do not install any lighting assembly closer
than 6" (15.24 cm) from any curtain or similar
combustible material.
• The product employs non-replaceable LED
light sources.

EN
6
• Contact the municipal building department to
learn about applicable local codes, permits
and/or inspections.
• This product is intended for use in
accordance with the National Electrical Code,
ANSI/NFPA 70, and the Canadian Electrical
Code, Part I, in non-hazardous locations, and
the Mexican Electrical Code [Instalaciones
Eléctricas (utilización), NOM-001-SEDE].
• This product should not be used with an
external dimmer.
SAVE THESE
INSTRUCTIONS
Intended Use
• This product is intended for residential use
only. It is not intended for commercial use.
• This product is intended to be used in dry
indoor areas only.

EN
7
CAUTION Risk of electric shock! DO
NOT USE WHERE DIRECTLY EXPOSED TO
WATER.
• This product is not intended for use with
emergency exits.
• No liability will be accepted for damages
resulting from improper use or non-
compliance with these instructions.
Product Description
2
3
100 %
50 %
0 %
14
WW*
CW*
DL*
* WW: 3000 K, CW: 4000 K, DL: 5000 K

EN
8
1Jumper connector
2Brightness selection touch switch
3Color temperature selection switch
4Knockout plug
Before First Use
• Check the product for transport damages.
• Remove all the packing materials.
DANGER Risk of suffocation! Keep any
packaging materials away from children – these
materials are a potential source of danger,
e.g. suffocation.

EN
9
Installation
DANGER Risk of electric shock!
Disconnect power before installation.
NOTICE This product must be mounted
onto a structurally sound surface that will
support weight of the fixture.

EN
10
Step 1
Prise open the desired knockout plug (4) for the
conduit connector (B).
Step 2
Loosen the screws and open the cover.