INSTALLATION INSTRUCTIONS
WARNINGS Please read the following information before installing and using your heated towel rack
CAUTION
OPERATING INSTRUCTION
TOOLS REQUIRED
SKUS
INTEGRATED SWITCH
CONTACT
WARRANTY
• These units should be installed by a certified electrician in accordance with the National Electrical Code (NEC)and the Canadian Electrical Code (CEC).
• The unit requires a 120 volt, 60 Hz power source and should be installed on a GFCI protected circuit.
• Plug-in units should be connected to a grounded outlet with a minimum rating of 10 amps.
• Follow instructions to ensure he learned is securely fix the wall. Unit is designed for drying towels. Under no circumstances should anyone climb on or hang on unit.
• Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
• As this is a heating device, the surface temperature can increase depending on the ambient temperature in the room and the number of tiles apply to the unit.
• Overloading the unit can cause the unit to become extremely hot and they result in a burn it touched and or damage the towels.
• The fasteners provided with installation kit are for convenience only are not suitable for all installation conditions.
• It is the ultimate responsibility of the installer to ensure proper mounting hardware is employed in attaching the unit to the wall.
• After installation, connect electrical power.
• Remove the protective cover from the switch and turn it to the on position.
• The indicator light will glow red and the towel warmer will start to heat — allow 10–20 minutes to heat up.
• This towel warmer has been designed to run continuously-turn off the switch or unplug the cord in the tower is not in use for long periods of time.
• Never use an extension cord for plug-in models.
Two year limited warranty
with proof of purchase
will apply if all terms and
conditions of sale are met
and installation instructions
are adhered to.
INCLUDED COMPONENTS
•The radiant collection features an
integrated on/off switch.
•Remove plastic cover after installation
•Switch is located on the bottom of the left
vertical bar.
•Press switch to power on unit.
•Switch will illuminate when on.
P - POLISHED | B - BRUSHED
TEL: 404-350-9738
PAGE - 1
! CAUTION —SURFACE OF UNIT IS HOT WHEN ON !
EMAIL:
customerservice@ambaproducts.com
www.ambaproducts.com
FAX: 404-355-0166
2 YEARS
THE WARRANTY COVERS
DEFECTS IN WORKMANSHIP
AND MATERIALS
FOR FULL WARRANTY AND
TERMS OF SALE VISIT:
www.ambaproducts.com/warranty
PARAMETER
CONFORMS TO UL STD.499
CERTIFIED TO CSA STD C22.2 NO.64
TOWEL WARMER | MODEL: RWHL-S
RATED VOLTAGE: 120V~
RATED FREQUENCY: 60Hz
RATED POWER INPUT: 150W
SERIAL NO:
HOUSEHOLD USE ONLY
DO NOT IMMERSE IN WATER
HOT SURFACE: AVOID CONTACT
UTILISATION DU MÉNAGE SEULEMENT
NE PAS PLONGER DANS L’EAU
SURFACE CHAUDE ÉVITER CONTACT
CAUTION:
RWHL-SP | RWHL-SB
RADIANT LARGE STRAIGHT HARDWIRED
