AMC PROXIMITY User manual

PROXIMITY
Installation Manual
FEATURES
Supply voltage: 13.8Vdc
Rated current draw: 60mA
Max. current draw: 80mA
It can be used for alarm panels of the S-Series (S8128 –S840 –S412)
Buzzer provides audible feedback for pre-alert and exit delay
Tamper Switch Disabling Jumper
LED indicators
oOrange LED on: PROXIMITY is communicating with the Alarm Panel
oYellow LED on: Area Armed
oRed LED on: New event to read in memory
oGreen LED on: System Ready (All zones are in the rest state)
oCourtesy Blue LEDs on: Key has been recognized

FIXATION AND CONNECTIONS
Open the housing unscrewing the front screws.
Take the posterior part of the reader and fix it to the wall..
Set the device address by using the dip-switches (refer to your Alarm Panel’s Technical Manual)
Connect the supply and data terminals to the bus terminals on the control unit board, do not leave any
copper debris on the circuit board. The wiring must be carried out only when the board is unsupplied. Not
respecting the correct installation guidelines will lead to malfunctioning or even damage of the keypad
Close the case by replacing the anterior part and fix the front screws..
Our products/systems comply with the essential requirements of EEC directives. Installation must be carried out following the local
installation norms by qualified personnel.
AMC Elettronica S.r.l. refuses any responsibility when changes or unauthorized repairs are made to the product/system. It is recommended
to test the operation of the alarm product/system at least once a month. Despite frequent testing and due to, but not limited to, any or all of
the following: tampering, electrical or communication disruption or improper use, it is possible for the product/system to fail to prevent
burglary, robbery, fire or otherwise. A properly installed and maintained alarm system can only reduce the risk that this happens.