American muscle Black Center Cap User manual

Black American Muscle Center Cap (79-14 All)
Tools Required:
1. Floor Jack
2. Lug nut wrench
3. Trim Remover
4. ( American muscle) Wheel Center cap
5. Gloves
Installation time: Approximately 1 hour

Installation procedure:
1. Safety first! Make sure engine is turned off and vehicle is parked on a level surface.
Engage Emergency Brake.
2. Once car is securely parked, use floor jack to lift Car. Use Lug Nut wrench and start
removing lugs (anticlockwise) for one wheel. For safety purposes, remove one wheel
at a time.

3. Detach wheel completely of the vehicle and lay the wheel on the floor. Flip wheel
over and use trim remover to pry center cap.

4. Lay tire on the ground. Simply place new center cap over center hole and snap it in
by gently pressing palm against cap.
5. Start to reinstall wheel back to vehicle. Use lug nut wrench and tighten lugs
clockwise. Repeat this procedure to remaining 3 wheels.

6. After All Center caps have been replaced. Slowly lower vehicle using floor jack.
Make sure all lug nuts have been torqued to factory specification. Make sure to
disengage emergency brake before driving.
Installation Instructions written by AmericanMuscle Customer Allen Syed 10/13/2014