American Standard Exposed Wall Mount Sink Faucet with Gooseneck Spout... User manual

Product names listed herein are trademarks of American Standard Inc.
©American Standard Inc. 2002
Exposed Wall Mount
Sink Faucet and Gooseneck Spout
ROUGHING-IN DIMENSIONS
.3&7
Certified to comply with ANSI A112.18.1M
7293.152
7293.252
NN
NN
'*/*4)&%8"--
NN
NNUPNN
UPQP
/15
'&."-&
NN%JB

NN
&$$&/53*$
ROUGH-IN

Prepare water supply lines per "Roughing-in
Dimensions". Install 1/2" NPT. SUPPLY NIPPLES
/15
'&."-&
5)3&"%4
'*/*4)&%
8"--
/15
4611-:/*11-& UP
%*"
01&/*/(
Congratulations on purchasing your American Standard faucet with
EverClean nish found only on American Standard faucets.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
with EverClean™ Finish
Installation
Instructions
Plumbers' Putty or Caulking
Adjustable Wrench Phillips Screwdriver
Channel Locks
TOOLS REQUIRED
EverClean Finish
• One wipe eortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel, Stainless Steel,
Polished Brass (or any combination of these nishes)

SERVICE

To change direction of handle rotation, proceed as follows:
Turn HANDLE to OFF position.
Remove HANDLE SCREW and HANDLE.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90pand replace.
Replace SPRING CLIP (1).
Replace HANDLE and HANDLE SCREW.
AERATOR may accumulate dirt causing distorted and reduced water flow.
Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90p.
90p
FINISH INSTALLATION
Apply thread sealant or teflon tape to SUPPLY NIPPLES (1).
Slide COUPLING NUTS (2) onto INLET SHANKS (3).
Thread ESCUTCHEONS (4) fully onto INLET SHANKS (3).
Thread INLET SHANKS (3) onto SUPPLY NIPPLES (1). Distance
between INLET SHANK (3) outlets must be 8" to match the VALVE (5).
Insert RUBBER WASHERS (6) into INLET SHANK (3).
Attach VALVE (5) to INLET SHANKS (3).
Tighten both COUPLING NUTS (2) firmly.

Remove AERATOR (1).
Turn HANDLES TO OFF POSITION.
Slowly turn water supplies on and check all connections for leaks.
Operate HANDLES to flush water lines thoroughly.
Turn HANDLES to OFF position and replace AERATOR (1).
Thread ESCUTCHEONS against finished wall.
TEST FAUCET

.3&7


1
1
1
2
2
3
4
5
6