American Standard Right Height Elongated Toilet Triumph Cadet... User manual

K99
© 2008 AS America Inc. Revised 2/08
SPACESAVER CADET® 3 ELONGATED
COMPLETE TOILET
❑ 2447.000
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• Space saving compact design - Elongated bowl
ts in the same space as a round front toilet
• 12" (305mm) Rough-in
• EverClean® surface inhibits the growth of stain
and odor causing bacteria, mold and mildew on
the surface
• Featuring the Cadet® 3 Flushing System
• Elongated siphon action jetted bowl with
2-1/8" trapway
• Internal trapway area fully glazed
• Generous 8" x 9" water surface area
• Close coupled tank with at tank cover for
superior storage
• Oversized 3" Flush Valve with Chemical
Resistant Flapper
• Speed Connect® tank to bowl coupling system
• Sanitary dam on bowl with four point
tank stabilization
• 2 color match bolt caps
• Chrome Trip Lever
• Color matched solid plastic seat with cover
• Wax ring gasket with closet bolts
• 100% factory ush tested
• 5 year warranty
Nominal Dimensions:
718 x 438 x 733mm
(28-1/4" x 17-1/4" x 28-7/8")
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures -
includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specication for
Non-Adjustability
SPACESAVER CADET® 3 ELONGATED
COMPLETE TOILET
VITREOUS CHINA
To Be Specied:
❏ Color: ❏ White
❏ Supply with stop
FINISHED WALL
FINISHED
FLOOR
C/L OF OUTLET
191mm
(7-1/2)
716mm
(28-1/4)
15mm (5/8)
102mm
(4)
470mm
(18-1/2)
381mm
(15)
305mm
(12)
296mm
(11-5/8)
267mm
(10-1/2)
C/L OF SEAT POST
HOLES 140mm
(5-1/2 CENTERS)
SUPPLY
AS
REQ'D.
439mm
(17-1/4)
733mm
(28-7/8)
*203mm
(8)
355mm
(14)
*152mm
(6)
236mm
(9-5/16)
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION
OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLY ARE SUGGESTED.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range
of tolerance established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.