Amerihome ATABLE User manual

ATABLE Bar Table Assembly Instructions
Max Weight Capacity 200 Lb
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper operation & maintenance. Every effort has been
made to ensure the accuracy of this manual. These instructions are not meant to cover every possible
condition and situation that may occur. We reserve the right to change this product at any time without
prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE,
DO NOT USE THIS PRODUCT!
DO NOT RETURN THIS PRODUCT TO THE RETAILER - CONTACT CUSTOMER SERVICE.
If you experience a problem, have questions or need parts for this product, visit our website
http://www.amerihomebrand.com or call Customer Service at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM
Central Time, or email: [e-mail]. A copy of the sales receipt is required.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
Base (C)
Tabletop (D)
Handle
Table Plate and Leg (E)
Screws
(F)
Foot Cap
(B)
Support Cylinder
(A)
201301
Remove Black Cap
Discard Before Assembly
ATTENTION!

ASSEMBLY INSTRUCTIONS
1. Remove Black Cap and discard before assembly.
2. Use a Hex Wrench (G)
to attach the Table Plate
and Leg (E) to the
underside of the Tabletop
(D) with the provided Hex
Bolts (F).
Insert the Support Cylinder (A) into the center of the tabletop.
3Set the foot cap over the hole in the Base. (C)
Insert the thicker end of the Support Cylinder into the
center hole of the Base, and press down FIRMLY.
4. Guide the open end of the Tabletop assembly over the
Support Cylinder and firmly press down on the tabletop.
To raise the tabletop, grasp the Handle and pull upward without
applying any weight. To lower, raise the handle upward and apply
weight to the tabletop.
DISASSEMBLY INSTRUCTIONS
Turn the table upside down. Hit the Metal Clip several times located in
The exact center of the bottom of the Base with a mallet or ball peen
hammer to disengage the locking mechanism. The Base will separate
from the Table Top and Support Cylinder.
To remove the Table Top from the Support Cylinder,
turn the table upside down, and strike the edge of
the Support Cylinder several times where it meets
the support leg of the tabletop. The Support
Cylinder and Table Plate and Leg will separate
with applied force.
2
3
Edge of Support Cylinder
Remove Black Cap
Discard Before Assembly
ATTENTION!
4
Metal Clip