Amerihome BSBWWPG2 User manual

BSBWWPG2
Bar Stool Assembly Instructions
Max Weight Capacity 330 Lb 201605
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper operation & maintenance. Every effort has been
made to ensure the accuracy of this manual. These instructions are not meant to cover every possible
condition and situation that may occur. We reserve the right to change this product at any time without
prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE,
DO NOT USE THIS PRODUCT!
DO NOT RETURN THIS PRODUCT TO THE RETAILER - CONTACT CUSTOMER SERVICE.
If you experience a problem, have questions or need parts for this product, visit our website
http://www.amerihomebrand.com or call Customer Service at 1-888-287-6981, Monday-Friday,
8 AM - 4 PM Central Time. A copy of the sales receipt is required.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE
WARRANTY FOR FUTURE REFERENCE
Remove Black Cap
Discard Before Assembly
ATTENTION!
Base
Seat
Back
Support
Cylinder
Foot Cap
Foot Rest
Seat

A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Place the wide end of
the Support Cylinder
into the center hole.
Place the Foot Cap over
the center hole on the
base plate.
Press the Support
Cylinder down firmly
into the center hole.
and press down
FIRMLY.
Press the Seat onto
the narrow end of
Support Cylinder.
Remove the Black Cap
and discard it before
assembly. The Orange
hydraulic button will
become visible.
ASSEMBLY INSTRUCTION
`
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, grasp the Handle and pull upward while sitting on the Seat.
To disassemble, turn the stool upside down, and hit
the clip on the center of the bottom of the base with
a rubber mallet to disengage the locking
mechanism. Then, turn the stool right side up, and
lift the Seat upward, pulling the Seat Assembly off
of the Support Cylinder.
Use allen wrench to
attach the Seat Plate
to the underside of the
Seat with the provided
4 SHORT screws.
Metal Clip
Use allen wrench
to attach the Back
Post to the Seat
with the provided 6
LONG screws.