Amerihome DTSC User manual

DTSC
Dining Table with 4 Chairs
Assembly Instructions
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper operation & maintenance. Every effort has been made to
ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and
situation that may occur. We reserve the right to change this product at any time without prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO
NOT OPERATE THIS PRODUCT!
HAVE QUESTIONS OR PROBLEMS? DO NOT RETURN THIS PRODUCT TO THE
RETAILER - CONTACT CUSTOMER SERVICE.
If you experience a problem or need parts for this product, visit http://www.amerihomebrand.com
or call our customer help line at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM Central Time. A copy of the sales
receipt is required.
FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
CALIFORNIA PROPOSITION 65 WARNING:This product may contain chemicals,
including lead, known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
201608

DTSC Assembly Instructions 2
ASSEMBLY
Hand Crafted & Made In USA. Real Hardwood - No Laminate, Particle Board Or Plywood Material Is Used.
READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below may lead to serious
personal injury or damage to property.
Table:
Made of 100% Solid American Maple Hardwood w/ Hand Scraped Textured Finish
Stain Resistant Catalyzed Finish
Self-Storing Leaves w/ Gear Slides For Easy Opening
Table With Leaf Measurements: 38” Deep x 60” Wide x 36” High Removable Table Leaf Measures 13” Width
Chairs:
Made of 100% Solid American Maple Hardwood
Fully Assembled
Do not exceed the maximum weight capacity. WEIGHT CAPACITY: Chairs = 350 Lbs Table = 500 Lbs
1 Piece Table Top
4 Pieces Table Legs
8 Pieces Each Nuts & Bolts
1) With the help of another person, rotate table top so
the top surface is flat on smooth surface.
2) Attach each table leg using nut and bolt using
pliers. Do not completely tighten until all 4 tables legs
have been attached. (Image A)
3) When all 4 table legs have been attached,
securely tighten all bolts. (Image B)
4) Close the latch mechanisms to lock the table top in
place. (Image C) Then rotate the table with the help
of another person and place in desired location.
(Image A)
(Image B)
(Image C)