Amerihome SFTABLE User manual

SFTABLE / SFTABLE-R
Bar Table Assembly Instructions
Max Weight Capacity 200 Lb
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper operation & maintenance. Every effort has been
made to ensure the accuracy of this manual. These instructions are not meant to cover every possible
condition and situation that may occur. We reserve the right to change this product at any time without
prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE,
DO NOT USE THIS PRODUCT!
DO NOT RETURN THIS PRODUCT TO THE RETAILER - CONTACT CUSTOMER SERVICE.
If you experience a problem, have questions or need parts for this product, visit our website
http://www.amerihomebrand.com or call Customer Service at 1-888-287-6981, Monday-Friday,
8 AM - 4 PM Central Time, or email : [email protected]. A copy of the sales receipt is required.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
201509
Support Cylinder
(B)
Base
(D)
Tabletop
(E)
Handle
Table Plate
and Leg (C)
Hex Bolts (A)
Hex Wrench (F)
Foot Cap
(G)
Foot
Rest
Remove Black Cap
Discard Before Assembly
ATTENTION!

ASSEMBLY INSTRUCTION
1. Use a hex wrench to attach the Table Plate
and Leg to the underside of the Tabletop with
the provided hex bolts. Attach the Foot Rest.
2A. A Black Cap protects the hydraulic
mechanism on the Support Cylinder.
2B Remove the Black Cap and discard it
before assembly. The Orange hydraulic
button will become visible.
3. Insert the Support Cylinder into the Table
Plate and Leg and press firmly.
4. Set the Foot Cap over the hole in the
Base. Insert the thicker end of the Support
Cylinder into the center hole of the Base,
and press down FIRMLY.
5. Guide the open end of the Tabletop assembly
over the Support Cylinder and firmly press down
on the tabletop.
To raise the tabletop, grasp the Handle and pull upward without applying any
weight. To lower, raise the handle upward and apply weight to the tabletop.
DISASSEMBLY INSTRUCTIONS
Turn the table upside down. Hit the Metal Clip
several times located in the exact center of the
bottom of the Base with a rubber mallet to
disengage the locking mechanism. The Base will
separate from the Table Top and Support Cylinder.
To remove the Table Top from the Support Cylinder, turn the table
upside down, and strike the edge of the Support Cylinder several times
where it meets the support leg of the tabletop. The Support Cylinder and
Table Plate and Leg will separate with applied force.
1
4
5
1
2A
2B
Metal Clip
3
3