Amerihome BS2088 User manual

BS2088 / BS2088C
Bar Stool Assembly Instructions
Max Weight Capacity 330 Lb 201307
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper operation & maintenance. Every effort has been
made to ensure the accuracy of this manual. These instructions are not meant to cover every possible
condition and situation that may occur. We reserve the right to change this product at any time without
prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE,
DO NOT USE THIS PRODUCT!
DO NOT RETURN THIS PRODUCT TO THE RETAILER - CONTACT CUSTOMER SERVICE.
If you experience a problem, have questions or need parts for this product, visit our website
http://www.amerihomebrand.com or call Customer Service at 1-888-287-6981, Monday-Friday,
8 AM - 4 PM Central Time. A copy of the sales receipt is required.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
Foot
Rest
Foot Cap
Support Cylinder
Seat
Seat Plate
Screws
Handle
Remove Black Cap
Discard Before Assembly
ATTENTION!

A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Remove the Black Cap and
discard it before assembly.
The Orange hydraulic
button will become visible.
Place the Foot Cap
over the Footrest.
Insert the Support Cylinder
into the center of the Seat
Plate
Insert the Support
Cylinder into the center
hole of the Footrest
Press down firmly
on seat to secure
into base.
ASSEMBLY INSTRUCTION
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, raise the Handle upward by sitting on the Seat.
To disassemble, turn the stool upside down, and hit
the clip on the center of the bottom of the Footrest
with a hammer or mallet to disengage the locking
mechanism. Then, turn the stool right side up, and
lift the Seat upward, pulling the Seat Assembly off of
the Footrest.
To separate the Support Cylinder from the Seat,
gently strike the Seat Plate with a rubber mallet until
the Seat and Support Cylinder have separated.
MODEL BS2088C ROLLING CASTER WHEEL ASSEMBLY
If you have Model BS2088C, remove the Stationary Feet by unscrewing
each one and replace them with the Caster Wheels.
Use an allen wrench to attach the
Seat Plate to the underside of the
Seat with the provided Screws.