
Maintenance
To ensure that the purifier operates at its best, a routine maintenance must
be performed. The frequency of the maintenance will greatly depend upon
the raw water quality and consumption of purified water.
Important Safety Instructions
• If the supply cord is damaged, it must be replaced by the original part in
order to avoid hazard
• Children should be supervised to ensure that they do not play with the
appliance
Note:
Replacement time of consumables such as filters and membrane is dependent on the
quality of raw water and quantity of water consumed.
• Switch on the power supply
• Wait approximately for 15
minutes so that the storage
tank is full**
• Switch off the power supply
• Drain off the storage tank by
opening the faucet to remove any
dust particles from the pipe and
storage tank
• Close the faucet & switch on the
power supply
• The purifier is ready to use
Starting-up the Purifier
**Tested & certified Flushing Time - 24 Hours.
• Storage tank must be drained
once a month.
• Replace sediment filter and
activated carbon filter once in
12 months or earlier if they get
clogged.
• Replace UV lamp once a year
• In the event of not using the
purifier for a long time (while
going for a holiday, tour, etc.),
ensure that you disconnect the
power supply, turn off the raw
water supply and drain out the
storage tank
Replacement of spare parts are as under:
- H-F0833-43QC 1752-Inline Sediment Filter 8"
- H-F0832-43QC 1751-Inline Carbon Filter 8"
- H-F0832-43QC Blue 1598-Post Carbon Filter (Blue)
- M-U1808-ENK UF Membrane 8”
- UV-L11W UV Lamp
5
Installation Instructions
AMI Sola Pure UV Purifier is a convenient and user-friendly
under-the-counter model.
• Single Phase 100-250 V AC, 50-60
Hz. supply, not more than 118
inches away from the point of
installation
• Raw water supply with ½ inch
nipple not more than 118 inches
away
• Installation space as per the
dimensions of the purifier
• Source water should be from cold
water line. Do not connect to hot
water line
• Install the purifier near a sink for
easy availability of inlet water
lines
• The system and installation need
to comply with state and local
laws and regulations
Installation Procedure:
• Fix the SS ball valve to the ¼ inch port of the 3-way
connector as shown in the figure
• Connect the 3-way connector to the raw water supply as
shown in the figure. The threaded end of the 3-way
connector is fit in–line with the raw water supply. The
other end can be connected to a tap or plugged off, if not
required
• Now connect one end of the white pipe 3/8” to the SS
ball valve and other end to the lower pushfit elbow fitting
on the back side of the purifier labeled as ‘Water In’
• Install the faucet on the kitchen sink or the slab.
Connect one end of the white pipe ¼” to the faucet
and the other end to the fitting connector labeled
as ‘Faucet’
• Before connecting the power supply, it is important that
you perform the following functions:
i. Open the SS ball valve (Handle parallel to the ball
valve) to start the flow of water into the purifier
ii. Wait for 2-3 minutes to ensure that the filters are
soaked in water
Recommended Site Preparations
6