AMIRIDIS-SAVVIDIS UNITED ARH-8509 User manual

OPERATION:
Before operating, please ensure that the installation and wire connection are correct.
1. Operating by Remote Control:
Direct the remote control towards the receiver within a distance of 6m (60° range).
Press “ON/OFF” button to start normal air flow, then press “NORMAL / WARM” to
get warm air. By adjusting “HIGH / LOW” button, you
can change the air volume, no matter how the unit is
working, under normal air or warm air condition. When
pressing “ON / OFF”, if the unit is working under normal
air condition, it turns off; if under warm air condition, it
will be turned off automatically after 2 minutes' delay
(during the delay, the green light indicator lights up).
2. Operating directly by the Receiver:
Press “Normal、Warm / OFF” button; the unit operates in normal air condition. To
select normal or warm air, or to turn off the unit, just press ”Normal、Warm / OFF”
again. By adjusting “HIGH / LOW” button, you can change the air volume, no
matter how the unit is working, under normal air or warm air condition. When
pressing “ON / OFF”, if the unit is working under normal air condition, it turns off;
if under warm air condition, it will be turned off automatically after 2 minutes' delay
(during the delay, the red light indicator lights up).
MAINTENANCE AND REPAIR:
1. Unplug the unit from the
power source prior to checking or maintaining.
2. Keep electric motor or other parts away from moisture, to avoid short circuit.
3. Regular checking and maintenance is recommended. Clean the dust off. Simply
clean with a cloth dampened in mild detergent.
4. Detachment of the unit must be executed only by professionals.
SPECIFICATIONS:
Model
Power (W)
Air Velocity
(m / s)
Length
(mm)
Weight
(kg)
Normal
Warm
HI
LO
ARH-8509
156
96
6000
7.5
900
14.9
ARH-8512
178
126
7200
1200
19
ARH-8515
207
154
9000
1500
23.3
NOTE: Rated voltage and frequency are stated as per rating label.
By AMIRIDIS –SAVVIDIS S.A.
AIR CURTAIN
WITH HEATING
Operating Instructions
Models : ARH-8509, ARH-8512, ARH-8515
Before using this unit, please read all the instructions carefully.

PRODUCT OUTLINE:
Open doors stand for a considerable amount of energy loss in a building.
A correctly installed AIR CURTAIN can reduce the heat loss through the
door as much as 90%. Except for the obvious energy savings in money, the
AIR CURTAINS prevents cold draught that can cause absence due to
illness and also allows shops to keep their doors open in winter time,
which has proven to attract more customers. AIR CURTAINS give a true
meaning to the slogan “a warm welcome”.
CONDITIONS OF USE:
Please DO NOT install the unit under following conditions:
1. Do not operate in areas with ambient temperature over 50°C or below
-10°C.
2. In steamy areas or areas with relative humidity over 95% at room
temperature.
3. In areas containing oily smoke.
4. In areas where materials or gases may cause explosion.
5. Near corrosive gases.
6. In areas where the unit may be sprinkled with water.
DIAGRAM:
[ Dimensions : mm ]
Model
A
L1
L2
ARH-8509
900
221
183
ARH-8512
1200
221
183
ARH-8515
1500
221
183
INSTALLATION:
1. Unscrew the mounting plate and take it off. (Fig. 1 、 Fig. 2)
2. Drill a hole following the instructions, then insert the bolt and fix it
with cement. (Fig. 3)
3. Hang the mounting plate and ensure that it is fixed. (Fig. 4)
4. Install the unit onto the mounting plate and ensure that it is safely
fixed. Then tighten the screws. (Fig. 5)
CAUTIONS / INSTALLATION:
During installation, please pay special attention to the following points in
order to obtain the ultimate efficiency.
1. Install on solid place to avoid vibrations when machine is running, and
also for safety reasons. This way, unnecessary noise caused by
vibration can be prevented.
2. AIR CURTAINS are designed for indoor use.
3. Choose the most suitable model depending on the height of the room.
If the unit is fixed too high, the shut-off distance will be affected and the
efficiency will be reduced.
4. The air is drawn in from the front of the unit and is blown out
downwards.
5. Several units can be mounted next to each other in case of wide door
openings. In this case, there must be a space 20-40mm between them.
6. During installation, there must be no gap between
the mounting plate and the wall.
7. The distance between the unit and the ceiling must
be at least 30mm.
8. The unit must be installed in horizontal position.
9. It is recommended to install the unit at a height of
at least 2.3m above the ground.
10. For safe operation, use the control switch to connect the electricity
source and the unit wire. If you are not going to use the unit for a long
time, shut the control switch down.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their
end-of-life, should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste
collection/ recycling centre.
In the European Union there are separate collection systems for used electrical
and electronic products. Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Amiridis –Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki –Greece
T: [phone] | F: [phone]
www.amiridis-savvidis.gr