Aml Acc-7715-ps User manual

User’s Guide

ACC-7715-PS

Inline Charger

Regulatory Information

All AML devices are designed to be compliant with rules and regulations in

locations they are sold and will be labeled as required. Any changes or

modifications to AML equipment, not expressly approved by AML, could

void the user's authority to operate the equipment.

Power Supply

Use only an AML approved power supply, output rated 12 VDC and

minimum 2.5A. The PWR-8050 Power Supply is certified to EN60950.

Disclaimer

AML reserves the right to make changes in specifications and other

information contained in this document without prior notice, and the

reader should in all cases consult AML to determine whether any such

changes have been made. The information in this publication does not

represent a commitment on the part of AML.

AML shall not be liable for technical or editorial errors or omissions

contained herein; nor for incidental or consequential damages resulting

from the furnishing, performance, or use of this material.

This document contains proprietary information that is protected by

All rights are reserved. No part of this document may be photocopied,

reproduced, or translated into another language without the prior written

consent of AML.

No user serviceable parts. Do not use if unit is damaged.

FCC Declaration of Conformity

Product Name: Inline Charger

Model Number: ACC-7715-PS

Radio Frequency Interference Requirements

This equipment complies with Part 15 of the FCC rules. Operation is subject

to the following two conditions: (1) This equipment may not cause harmful

interference, and (2) this equipment must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference

when the equipment is operated in a residential environment. This

equipment generates uses and can radiate radio frequency energy, and

if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If you

determine the equipment does cause harmful interference to radio or

television reception (this may be determined by monitoring the interfer-

ence while turning the equipment off and on), you are encouraged to try

to correct the interference by one of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

· Consult the dealer or an experienced radio or TV technician for help.

Radio Frequency Interference Requirements - Canada

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003

du Canada.

Marking and European Economic Area (EEA)

Products intended for sale within the European Union are

marked with the CE mark which indicates compliance to

applicable Directives and European Normes (EN), as follows.

Amendments to these Directives or EN’s are included.

· Electromagnetic Compatibility Directive 89/336/EEC

· Low Voltage Directive 73/23/EEC