AML ACC-7725 User manual

User’s Guide
ACC-7725
Charging Cradle
Regulatory Information
All AML devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required. Any changes or
modifications to AML equipment, not expressly approved by AML, could
void the user's authority to operate the equipment.
Power Supply
Use only an AML approved power supply, output rated 12 VDC and
minimum 2.5A. The PWR-8050 Power Supply is certified to EN60950.
Disclaimer
AML reserves the right to make changes in specifications and other
information contained in this document without prior notice, and the
reader should in all cases consult AML to determine whether any such
changes have been made. The information in this publication does not
represent a commitment on the part of AML.
AML shall not be liable for technical or editorial errors or omissions
contained herein; nor for incidental or consequential damages resulting
from the furnishing, performance, or use of this material.
This document contains proprietary information that is protected by
copyright.
All rights are reserved. No part of this document may be photocopied,
reproduced, or translated into another language without the prior written
consent of AML.
No user serviceable parts. Do not use if unit is damaged.
FCC Declaration of Conformity
Product Name: Terminal Charger
Model Number: ACC-7725
Radio Frequency Interference Requirements
This equipment complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This equipment may not cause harmful
interference, and (2) this equipment must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential environment. This
equipment generates uses and can radiate radio frequency energy, and
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If you
determine the equipment does cause harmful interference to radio or
television reception (this may be determined by monitoring the interfer-
ence while turning the equipment off and on), you are encouraged to try
to correct the interference by one of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
· Consult the dealer or an experienced radio or TV technician for help.
Radio Frequency Interference Requirements - Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
Marking and European Economic Area (EEA)
Products intended for sale within the European Union are
marked with the CE mark which indicates compliance to
applicable Directives and European Normes (EN), as follows.
Amendments to these Directives or EN’s are included.
· Electromagnetic Compatibility Directive 89/336/EEC
· Low Voltage Directive 73/23/EEC
Communication Ports
The ACC-7725 Charging Cradle has two communication ports and
one power jack located on the rear of the cradle. The cradle itself
has no internal or external settings that can be changed.
USB Type A
Connect to a device
(mouse, keyboard, USB drive)
USB Type B
Connect to a PC
(transfer files, software development)
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
www.amltd.com • 800.648.4452
© 2020 AML
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015

The Charging Cradle
The cradle automatically charges the mobile computer battery
while it is resting in the cradle. The cradle also includes an extra slot
to charge a spare battery. The Charging Cradle is designed to
accommodate the mobile computer with or without the optional
pistol grip handle.
The Charging Cradle has three indicator lights:
- Indicates that the charging cradle power is on or off.
- Indicates the mobile computer main battery charge status.
- Indicates the spare battery charge status.
When the battery charge LED is red, the battery is currently
charging. When the battery charge LED is green, the battery is fully
charged. A fully discharged battery takes about 4 hours to
completely recharge. When both the spare battery and mobile
computer are charging in the cradle at the same time, the spare
battery will take longer to fully charge.
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
Spare Battery
Introduction
The ACC-7725 Mobile Computer Charging Cradle charges any
M7700 Striker or M7800 Scepter Mobile Computer and the spare
battery.
About This Guide
This guide provides instructions on setting up and using the
ACC-7725 charging cradle.
Set Up
Setting up the cradle includes unpacking, connecting the power
supply, and positioning the cradle on a tabletop.
Unpacking the Cradle
The shipping box includes the following:
· One ACC-7725 Charging Cradle
· One PWR-8050 Power Supply (12 VDC, 2.5 A)
· This User’s Guide
Connecting the Power
The PWR-8050 power supply, included with the charger, is intended
for 120VAC operation.
To connect power to the cradle:
1. Plug in the PWR-8050 power supply to a standard 120 VAC
electrical outlet.
2. Connect the plug on the end of the power supply into the round,
barrel-jack connector, marked “12VDC” on the back of the cradle.
3. After 2 seconds the cradle power LED, on the front panel, will
illuminate red to indicate power is connected.
Charging
Set the M7700 Striker or M7800 Scepter Mobile Computer into the
cradle and it will begin charging immediately.
Indicator Lights
Troubleshooting
Cradle power indicator
does not light.
Symptom Cause Correction
Cradle is not receiving
power.
Make sure the
PWR-8050 power supply
is securely plugged into
the electrical outlet
and its power cord is
securely connected to
the cradle.
Mobile Computer
Indicator does not
illuminate.
Mobile computer is not
firmly seated in the
cradle, or there is no
battery in the device.
Misalignment occurs
when cradle contacts
are bent or damaged.
Make certain there is a
battery in the device,
and that the device is
firmly seated in the
cradle. Return cradle to
an AML repair center for
corrective action.
Spare Battery Indicator
does not illuminate.
Spare battery is not
seated properly in the
spare battery charging
compartment.
Reseat the spare
battery in the spare
battery charging
compartment.
Cradle Power
Indicator
Mobile Computer
Indicator
Spare Battery
Indicator
RED = The cradle has power from the power supply.
OFF = The power supply is disconnected or not
plugged into the electrical outlet.
RED = The mobile computer is charging.
GREEN = The mobile computer is fully charged.
OFF = The mobile computer is not in the cradle.
RED = The spare battery is charging.
GREEN = The spare battery is fully charged.
OFF = The spare battery is not in the cradle.