AMT Datasouth N3300 SERIES Troubleshooting guide

N3300 SERIES QUICK START UP PROCEDURE
(For Detailed Instructions - See User's Manual) BBF-104832 Rev.A
1. Remove top packing material.
2. Grab printer at midpoints indicated. Carefully lift printer
from box and remove bag.
(CAUTION: Printer Weighs Approximately 45 lbs).
3. SAVE SHIPPING BOX AND PACKING
MATERIALS!
4. Install ribbon using instructions provided with ribbon box.
5. Align lower front of printer with table edge. (For
improved forms loading and feeding, use the TG-DOC printer
stand available from your distributor).
6. Attach appropriate communication cable from your
computer.
7. Verify correct voltage setting (U.S.A. = 115v).
8. Attach power cord and turn power on.
9. Unlock right tractor and position for form width.
10. Equally space ALL paper guides and supports.
11. Open both tractor doors, load form, and close tractor
doors.
12. Verify that left form edge is in line with alignment mark.
13. Adjust right tractor SLIGHTLY to remove slack in form
and lock tractor. (Do Not Over-Tension Form!)
14. Forms should be positioned to feed straight, if not,
reposition forms. (For dual path printers - see User's Manual).
-over-

15. Load form by pressing "Load" key.
16. Open keypad door to access setup mode.
17. Press "Adjust Form" key.
18. Use "Value" keys to position bottom of FIRST PRINT
LINE to top of tear bar. Press "Adjust Form" key again.
19. (If your form is 9.5" x 11", go to step 24). Press "Quick
Access" key until [Form Length] is displayed.
20. Use "Value" keys to set form length in number of lines.
(Example: 3.5" long x 6 lines/inch[default] = 21). Press
"Enter".
21. Press "Feature ÙÙ or ÚÚ "key until [Right Margin] is
displayed.
(WARNING: NEVER PRINT OFF EDGES OF
FORM!)
22. Use "Value" keys to set right margin position in number
of characters. (Example: 6" wide x 10 char/inch [ default ] =
60). Press "Enter".
23. Attach to the network using the BNC/UTP (Ethernet), or
BNC/UTP/STP (Token Ring) labeled connector on the back of
the printer.
24. Press "Quick Access" key until [Print LAN Config] is
displayed. Press "Enter".
25. Note the Node Name, Default Printer Names, Ethernet
Address, and FServer Names for future reference.
26. Close keypad door and press "Profile" key to save
settings.
27. Press "On/Off Line" key to display [On Line] (Green
light will remain on).
28. Refer to the N-Series Installation and User Guide
Supplement for detailed information on installing the N-Series
printer for your specific Network Operating System (NOS) and
Protocol.
NOTE: When using the included "enstall" program for UNIX installation, select "NETQue" when
prompted.

(For Detailed Instructions - See User's Manual)
REPACKAGING DIAGRAM
(Save Carton And All Shipping Materials)