AMTC FOAMFLO ASD-500 User manual

Installation Diagram
™
®
ASD-500 FOAMFLO
AUTOMATIC FOAM SOAP DISPENSER
INSTALLATION & OPERATION MANUAL
Installation Instructions (refer to installation diagram above)
Battery Pack
4-D Size
(Batteries Sold Separately)
Reset Button
Foam Soap Bottle
(800 mL)
Spout
Spacer Sensor Cable
Mounting Bracket
Countertop or Sink
Max. Thickness: 2” (50mm)
AD05
6 Volt AC Power Adapter
(Optional-Sold Separately)
(Optional)
1. If hole is not present drill a 1” (25.4mm) hole on countertop (refer to installation template on page 3).
2. Mount the spout onto the countertop or sink and hand tighten mounting bracket and spacer without damaging sensor cable.
3. Install batteries into battery pack and mount battery pack onto back wall using provided hardware
(battery pack must be installed within 15” (380mm) of spout).
Note: An optional 6 Volt AC power adapter (Part# AD05) can be purchased separately if electrical power is required.
4. Screw soap bottle coupler onto threaded stem and hand tighten.
5. Fill up bottle with foam soap (Important: Use low viscosity non-lotionized foaming soap with no abrasives).
*Viscosity Range: (mPa•s or Cp): 1-100 / pH Range: 5.5 - 8.5
*Failure to use soap products within the required range of viscosity and pH may result in damage to product and
void warranty.
6. Screw soap bottle onto soap bottle coupler and hand tighten.
7. Connect sensor cable onto battery pack (you will hear pumps and soap will purge for approximately 5 seconds).
8. Soap dispenser is now ready for use.
Soap Bottle Coupler
Threaded Stem
Low Battery Indicator
Low Soap Indicator
Flashing BLUE LED
Flashing RED LED
Foam soap refill only
(Solo jabon de espuma)
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
www.amtcorporation.com
Attention:
Make sure sensor cable is passed
through the opening of the spacer
to avoid damage.
Page 1 of 3
Parts List
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
www.amtcorporation.com
Foam soap refill only
(Solo jabon de espuma)
A
C
F
GH
D E
I
(Optional-Sold Separately)
ASD-500 ASD-500EL
A-1
Ref # Description Part #
A
C
D
E
F
G
HBattery Pack
800ml Soap Bottle
Mounting Screws
Soap Bottle Coupler
Mounting Bracket
Spacer
Spout
ASD-5BP
ASD-5SB
ASD-5MSC
ASD-5SBC
ASD-5MB
ASD-5SPA
ASD-5SPT
IAD05 6-Volt AC Power Adapter
(Optional)
J
AD05-2 6-Volt AC Power Adapter
w/Extension for 2 Devices
K
AD05-2-EXT Extension Only for AC
Power Adapter
A-1 EL Spout (6” Long)
ASD-5SPTEL
B
BSpout Filter Assembly
ASD-5FA
K
(Optional-Sold Separately)
J
(Optional-Sold Separately)

Page 2 of 3
Foam soap refill only
(Solo jabon de espuma)
Foam soap refill only
(Solo jabon de espuma) www.amtcorporation.com
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
Foam soap refill only
(Solo jabon de espuma)
Reset Button
www.amtcorporation.com
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
1. Flashing Red LED Indicates Low Soap 2. Unscrew Foam Soap Bottle 3. Refill Foam Soap Bottle
4. Re-install Foam Soap Bottle 5. Press and Hold Reset Button for 7 Seconds to
Prime New Soap and Reset Flashing Red LED.
Refill Soap When Soap Level is Approx. 3/4” (20mm)
3/8”
(10mm)
www.amtcorporation.com
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
Foam soap refill only
(Solo jabon de espuma)
Flashing Red LED
3/4”
(20mm)
Max Filling Level is
Approx. 3/8” (10mm)
From Top of Bottle
Troubleshooting:
Flashing BLUE LED
Flashing RED LED
Problem Solution
Batteries are low/drained. Replace all 4 batteries (D-size).
Soap is low or empty. Refill soap bottle and press and hold reset button for 7 seconds to prime new soap and reset LED.
Soap does not come out of spout Spout filter is dirty and won’t pump soap through the spout. Clean or replace spout filter assembly.
Soap Refill Instructions:
Soap dispenses in liquid form
and not foam
Wrong soap was used and pump is dirty. Refill soap bottle with water and press and hold reset button for 7 seconds to
prime water through the unit. This should be repeated until only water dispenses and soap is completely flushed out.
Once unit is flushed out, refill soap bottle with foaming soap. Prime unit again until soap comes out.
™
®
ASD-500 FOAMFLO
AUTOMATIC FOAM SOAP DISPENSER
INSTALLATION & OPERATION MANUAL
*Viscosity Range: (mPa•s or Cp): 1-100
pH Range: 5.5 - 8.5
*Failure to use soap products within the
required range of viscosity and pH may
result in damage to product and void
warranty.
Important: Use low viscosity non-lotionized
foaming soap with no abrasives.

Page 3 of 3
Advanced Modern Technologies Corporation
19800 Nordhoff Place, Chatsworth, CA 91311
Tel: [phone] Toll Free: [phone] Fax: [phone]
www.amtcorporation.com
™
Warranty
AMTC WARRANTS THE ASD-500 SOAP DISPENSER TO BE FREE OF DEFECTS IN MATERIAL AND
WORKMANSHIP FOR A PERIOD OF THREE (3) YEARS FROM DATE OF PURCHASE, WHEN PROPERLY
INSTALLED AND UNDER NORMAL USE AND SERVICE. THESE PROVISIONS DO NOT INCLUDE THE
BATTERIES SHIPPED WITH THE PRODUCT. A DEFECTIVE PRODUCT MAY BE RETURNED TO AMTC
OR ITS AUTHORIZED REPRESENTATIVES WITHIN THREE (3) YEARS FROM DATE OF PURCHASE
WITH THE PROPER INVOICE OF PURCHASE. AMTC, AT ITS DISCRETION, WILL REPLACE OR REPAIR
DEFECTIVE PRODUCT AT NO CHARGE. CLAIMS FOR LABOR, TRANSPORTATION, AND ANY OTHER
INCIDENTAL COSTS WILL NOT BE ALLOWED. AMTC WILL NOT BE RESPONSIBLE FOR ANY
CONSIDERABLE DAMAGES OF ANY KIND WHATSOEVER.
FOR TECHNICAL SUPPORT PLEASE CALL TOLL FREE 1-800-874-7822 OR VISIT OUR WEBSITE
AT WWW.AMTCORPORATION.COM.
MAKE SURE TO VISIT OUR WEBSITE PERIODICALLY FOR INFORMATION ON NEW PRODUCTS AND
TO DOWNLOAD ANY IMPORTANT PRODUCT DOCUMENTS THAT YOU MAY NEED IN THE FUTURE.
Installation Template for Model ASD-500 Spout (Not used for Model ASD-500EL)
3-3/4”
(95mm)
REF
Counter Top
Sink
Center Drill Point
1” (25.4mm) Hole
Spout Footprint
1-1/2” (38 mm)
(Scale 1:1)
Minimum To
Edge of Sink
Basin
Dispenser can be installed
on the left or right of the sink
Counter Top
Sink
REV. 02/19
™
®
ASD-500 FOAMFLO
AUTOMATIC FOAM SOAP DISPENSER
INSTALLATION & OPERATION MANUAL