Amway eSpring Configuration guide

Cleaning &
Maintenance Guide
Contents :
- Clean The Diverter
- Status Indication

eSpring Installation & Maintenance Guide
Rotate diverter to treated
mode. Remove the
diverter and twin tubing.
Using the tip of a toothpick,
remove gasket support from
treated water port.
Seperate the Black &
White gasket.
To keep the diverter clean at all times, dismantle it
for cleaning periodically.
Remove cap & collimator from treated
water port. It is normal to see crystallised
minerals here.
Mix 40ml Dish Drops™ Concentrated Dishwashing
Liquid with warm water to make into a 1L solution.
Soak all parts in this solution for 20 minutes.
Page 1
Clean The Diverter
Step 1 :
Step 4 :
Use a toothbrush to clean difficult areas.
Rinse well with water.
Repeat all steps until desired results are
achieved before replacing everything
into their original positions.
Step 6 :
Step 7 :
Step 8 :
Step 5 :
Step 2 : Step 3 :

eSpring Installation & Maintenance Guide
Normal
When the electronic display is at this status
- It indicates that the water treatment system is
working properly.
Filter cartridge not recognised
If the electronic display is at this status and
a repeated beeping sound is heard.
- It indicates that the filter cartridge is not
recognised or not properly installed.
Please reinstall the cartridge.
Page 2
Status Indication
When it is switched to ‘treated water’

eSpring Installation & Maintenance Guide
UV lamp malfunction
If the electronic display is at this status and
a repeated beeping sound is heard.
- It indicates that the cartridge needs to be change.
Water treatment malfunction
If the electronic display is at this status and
a repeated beeping sound is heard.
It indicates that the water treatment system may be faulty.
** Please unplug the power adapter, wait for 5 minutes then plug in the power adapter again.
If the problem persists, please contact [e-mail] (Malaysia) or [e-mail] (Singapore)
Page 3
Status Indication
When it is switched to ‘treated water’

eSpring Installation & Maintenance Guide
Water treatment malfunction
(Electronic display faulty)
No power
It indicates that the electronic display may be faulty.
If the electronic display is at this status and
a repeated beeping sound is heard.
If the electronic display is at this status.
It indicates that there is no power supply.
Please plug in the power adapter.
Page 4
Please contact [e-mail] (Malaysia) or [e-mail] (Singapore)
Status Indication
When it is switched to ‘treated water’