AMX AXD-CA10 Technical manual

SHEET
C
NOTICE: This drawing is the
property of AMX Corporation.
that is not generally known
shall be confidential except
to the extent the information
has been previously established.
This drawing may not be copied,
for manufacture or sale without
reproduced, or used as the basis
All information contained herein
written permission. DO NOT SCALE THIS DRAWING.
UNLESS OTHERWISE SPECIFIED:
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
XXX = .005
= +.006 -.005
= +.008 -.005
TOLERANCE ON HOLE DIAMETERS:
ALL DIMENSIONS IN INCHES.
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
ANGLES: +/- 1.0°
UNDER .250 ú
.250 TO .500
OVER .500
= +/- .005
ENGR SERV
PROD ENGR
ENGINEER
THIRD ANGLE
PROJECTION
DRAWN
REL DATE REV APPRREL APPR
SIZE DWG. NO.SCALE REV.
QUALITY
MATL SUP
REV ECN APPROVEDDESCRIPTION
REVISIONS
DATE
A--- RELEASED TO PRODUCTION 12/22/98
PICTORIAL,
AXD-CA10/CV10/CG10 /PB,
LOW PROFILE BACKBOX
95-0951-04
95-0951-04-C
C
FULL
1 OF 1
TM
RBF 10/21/98
LW 1/14/99
RBF 12/22/98
III 12/22/98
BS 7/3/03
LEE 1/14/99
B2631 UPDATE TB 7/30/01
C3805 ADD CONNECTORS 7/3/03
JM
PS
KZ
BS
AK