AMX ALD-D48 User instructions

TOLERANCE ON HOLE DIAMETERS:
ANGLES: +/- 1.0°
ALL DIMENSIONS IN INCHES.
DO NOT SCALE THIS DRAWING.
UNLESS OTHERWISE SPECIFIED:
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
written permission.
NOTICE: This drawing is the
property of AMX Corporation.
that is not generally known
shall be confidential except
to the extent the information
has been previously established.
This drawing may not be copied,
for manufacture or sale without
reproduced, or used as the basis
All information contained herein
SHEET
PROJECTION
MATL SUP
QUALITY REV.DWG. NO.SIZE
REV APPRREL DATE
DRAWN
ENGR SERV
PROD ENGR
ENGINEER
THIRD ANGLE
REL APPR
= +/- .005UNDER .250 ú
.250 TO .500
OVER .500
XXX = .005
= +.006 -.005
= +.008 -.005
D
SCALE:
APPROVEDDATEREV ECN DESCRIPTION
REVISIONS
A4619 RELEASE FOR PRODUCTION 1/30/03
PICTORIAL
ALD-D48
95-2604-01
95-2604-01
A
FULL
1 OF 1
J.L. 01-07-03
DB 1/30/03
JL 1/30/03
KZ 1/30/03
AM 1/30/03
AK 1/30/03